EHC DSR solaris Series, DSR solaris PSO500.380.58, DSR solaris PSO1000.510.58, DSR solaris PSO2000.770.58, DSR solaris PSO1500.640.58 Installation & Operating Instructions Manual

RCL-CXXW_EHC_R ev.0_05-12-2018

1/26

500w-1000w-1500w-2000w

DSR solaris Electric Heater

INSTALLATION

&

OPERATING INSTRUCTIONS

THESE INSTRUCTIONS SHOULD BE READ CAREFULLY

AND RETAINED FOR FUTURE REFERENCE.

BE SURE TO OBSERVE ALL

LABELS AND WARNINGS

ON THE APPLIANCE

RCL-CXXW_EHC_R ev.0_05-12-2018

2/26

This appliance is not intended for use by persons (including children)

with reduced physical, sensory or mental capabilities, or lack of
experience and knowledge, unless they have been given supervision or
instruction concerning use of the appliance by a person responsible for

their safety. Young children should be supervised to ensure that they do

not play with the appliance.

1. General Information

EHC Electric heaters have been designed using the latest technology to
create an elegant solution for all hard to heat situations. They can be installed
in almost any location, apart from the safety restrictions noted within this
manual. This range has been developed to provide a flexible solution for
electric heating in Domestic properties, Conservatories, Holiday homes,
Offices and in any temporary heating situation. The heaters can be simply
plugged into a standard socket or hard wired into a fused spur.

Wi-Fi Control

DSR Wi-Fi Control is our easy to use App based control system. To take
benefit of this feature you simply need to purchase and connect the heaters to
our DSR Gateway. The DSR Wi-Fi App gives you total control of all your
heaters independently or in groups if required. The system can be controlled
from a Computer, Smart phone or Tablet using our Free App. Additionally by
adding an optional Power Meter to the system will give you further
controllability over the total available power within your home. The Power
Meter constantly monitors the whole house electrical demand. If the set
demand is reached, the system will temporarily disable your chosen heaters
until the demand is reduced, the heaters will then be reactivated automatically.

All EHC heaters are manufactured to the highest safety and quality Standards.
Each heater is CE Marked and carries all the necessary European Approvals.
Each heater is fully checked and tested prior to leaving the factory. We hope
you enjoy the comfort provided by this superior product and we look forward to
being of assistance to you in the future.

RCL-CXXW_EHC_R ev.0_05-12-2018

3/26

GENERAL SAFETY INSTRUCTIONS

1. Please read these instructions fully before starting the device for the first
time. Do not discard the instructions, guarantee, your invoice and, if
possible, the complete packing.

2. The guarantee will be invalidated if the product is not installed or handled
in- line with the recommendations of this manual.

3. Before connecting the appliance, make sure the mains voltage is
sufficient and in correspondence to the marked labels of the appliance.

4. Check the power is sufficient to supply the appliances. Note; the total draw
of the heaters current must not exceed the capacity of the circuit breaker
that protects them.

5. This heater cannot be used in rooms with presence of gases or other
flammable products (glues, etc...)

WARNING: To prevent overheating, Do Not cover or use the heater to dry

6.
clothes.

7. Make sure the power cable or other objects do not come into contact with
the heater surface while in operation.

8. If the power cable becomes damaged it must be replaced by the
manufacturer or a suitably qualified trades person. Failure to comply may
compromise your safety and void your warranty.

9. Check the device and the supply cord regularly. Do not turn the device on
if it is damaged.

10. PRECAUTION: Some parts of this product can reach high

temperatures and could cause burns. Pay special attention when
children or vulnerable people are near this heater.

11. Do not place the device directly under a power socket.

12. Children under the age of 3 should not be allowed to touch or play with the
heater and should be supervised at all times.

13. This device can be switched on/off by children over 8 years of age, as well
as by people with reduced physical, sensory or mental capabilities, only
when suitably supervised adult is present and only when they have been
provided instructions to use of the device. Cleaning must only be carried
out by an appropriate adult

RCL-CXXW_EHC_R ev.0_05-12-2018

4/26

GENERAL SAFETY INSTRUCTIONS

Warning: Do not use this heater near baths, showers or swimming pools.

14.
It should not be possible to access the device's controls from the bath,
shower or any other surface that is in contact with water. (Its use in zones
0 or 1 in bathrooms is totally prohibited: seek advice from a qualified
electrician).

15. For greater safety, this appliance is provided with a device that interrupts
its operation in the case of overheating.

16. This heater has been designed exclusively to be fixed to the wall. For
further information on the fixing systems, consult the section
"INSTALLATION AND WALL MOUNTING" of this manual.

Do not use accessories that have not been recommended by the

17.
manufacturer, as they could entail a potential risk to the user, and damage
the device. Use only original accessories.

18. Keep all the packaging elements (plastic bags, cardboard and
polyethylene) out of the reach of children, as they can cause potentially
dangerous situations.

19. Use this device only for domestic / light commercial use and the tasks for
which it has been designed. This device has not been designed for
industrial use. It must not be used outdoors, in greenhouses or for
animal husbandry. Keep it away from heat, direct sunlight, humidity and
cutting tools. Do not under any circumstances immerse in water or use this
device with wet hands. In the case of humidity or water in the device,
immediately disconnect the power supply and do not touch the wet parts.

20. Do not attempt to service the device yourself. Contact a qualified
technician.

21. To disconnect the heater from a mains socket, pull the plug, never the
supply cord.

22. Respect the "SPECIFIC SAFETY INSTRUCTIONS FOR THIS
APPLIANCE"

RCL-CXXW_EHC_R ev.0_05-12-2018

5/26

SPECIFIC SAFETY INSTRUCTIONS FOR THIS DEVICE

• The appliance must remain in a vertical position.

• Make sure the appliance is secured at all times. Please adhere to the

installation distances indicated in this guide.

• Do not hang any objects in front, behind or on top of the device.

• Always ensure that the inlet and outlet air flow are not obstructed.

• Always install the device so that it cannot enter into contact with any

combustible material, such as curtains or towels.

• To clean the device, consult the instructions in the "MAINTENANCE"

section. If water enters the heater it could seriously damage the device.

• Do not insert any object through the grille or inside the device.

• This heater is designed to be connected by plug to the electric installation

and fixed to the wall installation. Follow the instructions in
"INSTALLATION".

Your Guarantee may be invalidated if the installation
instructions have not been followed

INSTALLATION

• Heaters can be heavy. Take adequate precautions when lifting and

maneuvering the heater. Always assess the load, and seek assistance
with heavy or awkward loads that are beyond your capabilities.

•

In order to maintain stability and to ensure its future safety in use, it is
essential that the heater is FIXED SOUNDLY TO A WALL and that the
brackets are mounted on a FIRM, LEVEL SURFACE.

• Care should be taken to avoid irregular surfaces.

• It is important that these instructions are strictly followed.

• Keep the following minimum safety distances to avoid fire risk due to high

surface temperatures of the appliance during heating cycles.

RCL-CXXW_EHC_R ev.0_05-12-2018

6/26

• CAUTION – This heater must not be located below or in front of a fixed

socket outlet.

• DO NOT POSITION under windows where curtains may contact the

heater.

• DO NOT PLACE THE APPLIANCE in the vicinity of a swimming pool.

• During the first use and for a few minutes, this device may occur smells

and noise due to the dilatation of some internal parts. This is normal, so
you must provide adequate ventilation. The smells are momentary and will
quickly dissipate.

• For greater efficiency, make sure to calculate the correct size of the heater

according to the surface of the room. We recommend contacting your
dealer or engineer to perform this calculation.

• The heater must be placed at a minimum distance of 15cm from any

combustible material, curtains, furniture, chairs, etc. (Fig.1).

• Allow for a minimum distance of 1m, from the front of the unit to any

obstacles (furniture, walls, curtains, for example) that could hinder its
operation or performance of the product.

• Keep a minimum distance of 15cm between the appliance and the side

walls and any other obstacles (walls, for example) that may affect its
function. Also keep a minimum distance of 35cm on top the appliance free
of obstacles and a minimum distance of 15cm from the floor.

RCL-CXXW_EHC_R ev.0_05-12-2018

7/26

Possible Shel f

Fig1

Minimum Clearances

Note: Only IPX4 heaters are suitable for installation in bathrooms which allows

for the heater to be installed within Zone 2 as per regulation 701.32.4

Regulation 701.411.3.3 of BS7671 means that all circuits within a location
containing a bath or shower will require RCD protection not exceeding 30 mA
and have the characteristics specified in regulation 415.1.

Local isolation should be provided for the heater, however, the isolation device
must be installed out with all zones and in compliance with regulation

701.512.3 and Section 53 of BS7671

Note: Heaters must be only installed in or out with zone 2 of a bathroom

RCL-CXXW_EHC_R ev.0_05-12-2018

8/26

WALL-MOUNTING

1. Place the template onto the floor and mark the drilling positions for
the heater brackets. Use the Screws & Plugs provided to fix the
brackets to the wall.

2. Attach the 2 adhesive spacers onto the
heater the back of the heater.

3. Hang the heater onto the brackets and lock into
position by the screwing the locking device into position.

Note: Take care not to over tighten as this may damage

the brackets.