EggBikes EggRider V2 Quick Start Manual

EggBikes - 20 May 2018
Applicability: bootloader v3, firmware v1.0.9, smartphone application: V1.0.1

1. Main screen content

● Battery percentage

● Connection status

● Voltage

● Riding profile (road or offroad)

● Speed (mph or kph)

● Error Code (if error is present)

● Headlight status (if headlight switched on)

● Riding Level

● Power (W), Current(A), or efficiency (watt per distance unit)

● Hour (if the app was connected previously) or total trip time

● Odometer

EggBikes - 20 May 2018
Applicability: bootloader v3, firmware v1.0.9, smartphone application: V1.0.1

2. Buttons:

Power: short press to turn on or off
Up: increase the assist level
Down: decrease the assist level
Mode: switch between road and offroad

Additionally, the following button combinations are available:

- When the display is off, Mode + Power to load default factory settings

- When the display is off, Up + Power to start in bootloader (5 seconds)

- Press Mode for 3 seconds to see trip data

- Press Down for 3 seconds to activate headlight and to dim the display

- Long press Mode for 3 seconds.While pressing it, short press Down to reset the trip data

Note: Settings, mode, levels, odometer and trip data is saved when the system is shut down by
pressing the power button. If the power supply is cut before pressing power button, the data is not
saved into the permanent memory.

3. Secondary screen (subject to content change)

Trip:

● Wh/distance

● Battery capacity estimation (dependent heavily on the current accuracy)

● Distance

● Avg speed

● Moving time

● Energy and Capacity consumed
Total:

● Energy and Capacity odometer

● Battery cycles (calculated using the declared capacity)

● Battery series resistance (calculated in the last hour or so)

● Longer term battery capacity (last 10 trips or so)

● Range (using the previous trip efficiency)