Egardia SIR-25 operation manual
Installation guide
Indoor siren
1
INSTALLATION GUIDE INDOOR SIREN
Congratulations on the purchase of your Egardia indoor siren.
Customer Service
Please visit www.egardia.com if you would like further information about the installation and use of
Egardia. The answers to a number of frequently asked questions can be found at
www.egardia.com/userquestions.
This package has been put together with care. Please contact our customer service if you would like
any help during installation or if something is missing from the package. Never return a package
without prior instruction from our customer service.
Indoor siren
The additional indoor siren is activated when an alarm is triggered. The indoor siren produces a
sound of up to 95 decibels. The indoor siren also sounds when the alarm is switched on or off, and
when delay times are set.
Position the indoor siren where the sound output is optimal, as in the hallway or at the back door.
This allows for an increase of the volume range when the alarm sounds, but also when the alarm is
correctly switched on or off.
The Egardia indoor siren needs to be plugged into an electrical socket.
Sound signals of the indoor siren: depends on the settings
Sound signals
Volume
Burglar alarm & panic alarm
Continuous
High
Fire alarm
Beep of 2 sec. followed by pause of
1 sec.
High
Flood alarm
Beep of 2 sec. followed by pause of
1 sec.
Low
Activate – ON
1 beep
High or low
optional
Activate – ON, partially
1 beep
High or low
optional
Deactivate
2 beeps
High or low
optional
Delay times
During delay time a beep per second
High or low
optional
OVERVIEW INDOOR SIREN
1. Status indicator & Register button – Shows the status of the indoor siren and also acts as a
register button for the indoor siren.
2. Siren – Produces a maximum sound level of 95 decibels.
3. Plug – Connects the indoor siren to a 90-230V socket.
Volume
The volume of the sound signals when activating or deactivating the alarm and during a delay time
can be set to high or low. Press the register button of the indoor siren for 3 seconds to change the
volume. When the button is released a beep sounds as an example.
Emergency power supply
The indoor siren has an emergency power supply. When the indoor siren is connected to a socket,
the emergency power supply is automatically charged. Should power fail or be interrupted by
sabotage you will be notified. Using its emergency power supply the indoor siren is able to operate
for approximately 12 hours.
Website Egardia
www.egar dia.c om
Loading...