Page 1
Wireless Gateway
Quick-Start Guide
SpeedStream
®
Part #007-0826-001
Page 2
Page 3
Page 4
Page 5
D
S
L
1
0
B
A
S
E
-T
U
S
B
P
W
R-
3
USB Installation Method
Option B:
RJ-11 DSL cable
Internet Connection
Internet Connection
w/two-to-one adapter
3
4
4a
Power Supply
5
1
USB Connection
to computer
2
Software Installation
Before installing the software, make sure your PC is equipped with the following:
• Windows®98, Windows®98 Second Edition (SE), Windows®2000 Professional,
Windows®Millennium Edition (Me), or Windows® XP
• 32 MB RAM
• Pentium-compatible 166 MHz processor or faster processor
• 12 MB available hard disk space
1. Insert the SpeedStream
®
Installation CD into your CD-ROM drive.
2. Click the Start button on the Windows
®
taskbar.
3. Select Run from the Start menu.
4. Type “e:\setup.exe” where “e” represents your CD-ROM drive.
Note: your CD-ROM drive letter may not be “e.”
5. Click the OK button.
6. The software installation program will start. Follow the on-screen directions to complete the software
installation. When prompted to attach the gateway, please refer to the instructions below.
Connect the SpeedStream DSL Gateway
1. Connect the USB Cable to the USB port at the rear of the gateway.
2. Connect the other end to the USB port on your computer.
3. Plug the DSL cable into the DSL port on the gateway.
4. Plug the other end of the cable into the phone jack.
4a. If using a two-to-one adapter, plug the cable into the open socket of your two-to-one adapter.
5. Plug the power adapter into the power outlet and gateway.
6. Power on the computer.
You have completed the installation of your SpeedStream
®
DSL hardware. Proceed to Step 3 to configure
your gateway and connect to the internet.
Page 6
Page 7
Page 8
Loading...