EFFI PV-800E User Manual

HOUSES NEED BREATH HOUSES NEED BREATH

Fresh air intelligent controller is designed for monitoring real-time

indoor temperature, humidity, and VOC concentration. Built-in gas

sensor has high sensitivity not only to VOC such as; ammonia,

formaldehyde, benzene, xylems, hydrogen, alcohol, carbon monoxide,

methane, propane, alkyl, styrene, propylene glycol, phenol and other

volatile organic compound. Also, to other air contaminants such as

wood, paper, cigarette smoke and a dozen combustion gases.The

output signal of fresh air controller can control the startup and speed

of ventilator directly. Can effectively improve indoor air quality;

create a healthy, comfortable, energy-efficient living and working

environment

Display

1. Humidity display

2. VOC concentration display

3. Standby time under time function

4. Temperature display

5. Working status display

6. Fan speed status

7. Working time under timer function

Pacific Heating & Cooling Technology Ltd.

9/28 Torrens Road Burswood, Auckland 2013

www.pacifichac.nz

Ph: 09-2652626 Fax: [phone]

Fresh Air Intelligent Controller

PV-800E

Good Indoor Air Quality Means

HOUSES NEED BREATH HOUSES NEED BREATH

Operation

MANUAL: The fan can be set at stop, low speed, medium speed, and high

speed by buttons and , then the fan will run according to the setting,

won’t be affected by temperature, humidity, VOC concentration and timer.

AUTO: under this mode, when VOC concentration exceeds its set value,

controller will increase the fan speed automatically. VOC concentration set
value should be set by button when enter parameter setting, VOC

concentration is recommended setting between 7.0 – 10.0 ppm. Under

auto mode, VOC concentration can be set by and , when VOC

concentration doesn’t exceed its set value (air is fresh), fan is at stop or

low speed. And under auto mode, controller can also control fan speed by

indoor temperature and humidity setting, when temperature or humidity
exceeds its set value, controller will also increase fan speed automatically.

1. TIMER: The fan will run and stop according to the set time, making the

fan run at low speed, medium speed or high speed need to press and

；Start running time of fan (ON-TIMER), stop running time of fan (OFF-

TIMER).

2.OFF status： No LCD display，the fan stop.

3.Parameter setting: Press to start parameter setting of VOC

concentration、ON-TIMER 、OFF-TIMER 、TEMPERATURE & HUMIDITY.

When entering the appropriate setting items, the corresponding value will

flick, adjust the value by and . Controller will return to normal

working condition and save setting parameter automatically if you won’t
press any buttons more than 5 seconds.

Specification

Dimension: 86×86×40mm

Warm-up time: 2 minutes (initial power warm up for 72 hours)

Fixing whole distance: 60mm (standard)

Response time: ≤10 seconds

Wiring terminal: Max 2.5 mm2 wire

Recovery time: ≤30 seconds

Rated voltage: AC110V - - 230V, 50/60Hz
Operating temperature: -10℃ --- +50℃

Standby Power: ≤1w.

Operating humidity: 5%RH——90%RH

Control power: ≤200W
Storage temperature: -10℃ - +60℃

Output interface: Three speed

Storage humidity: ≤60%RH
Temperature display range: 0℃—50℃

Life: ≥10 years

Humidity display range: 25%RH—90%RH

VOC display range: 0.3ppm—25.0ppm

Wiring & Installation diagram