Edwards Signaling 111 User Manual

WIRING DIAGRAM:

BLACK
WIRES

POWER

IN

WHITE
WIRES

WARNING:

TURN OFF ELECTRICITY, remove fuse or switch off circuit
breaker.

THERE IS A RISK OF FIRE AND ELECTRICAL SHOCK.
FIXTURE SHOULD BE INSTALLED BY A QUALIFIED
ELECTRICIAN IN ACCORDANCE WITH NATIONAL & LOCAL
ELECTRICAL CODES.

FIXTURE INSTALLATION:

1. Make sure electricity is turned OFF.

2. Put weatherproof gasket in position under cover.

3. Connect wires as shown in diagram.

4. Attach fixture to junction box with (4) screws supplied.

5. Install lamp glass globe, and aluminum guard. Tighten set
screw.

6. Turn on power.

LAMP INSTALLATION
OR RELAMPING:

1. Use 150 watt incandescent lamp Maximum. See socket for
proper selection.

2. Disconnect power and let lamp cool if it was in operation.

3. Loosen set screw and unscrew aluminum guard and glass.

4. Replace lamp.

5. Replace glass globe and aluminum guard, reconnect power.

CHESHIRE, CT 203-699-3300
FAX [phone] (CUST. SERV.)
203-699-3078 (TECH. SERV.)

P/N 3100464 ISSUE 1

© 2002 EDWARDS