Mobile Jump Starter for Cars with
Power Bank, 9.000 mAh
User Manual
31889
Please read this manual before using this product.
Failure to do so can result in serious injury.
Thanks to choose our Portable Multi-Function Emergency car Jump
Starter and before using it, please read this manual carefully for
reference.
SAFETY & MAINTAINANCE
WARNING!
READ AND UNDERSTAND ALL INSTRUCTIONS
Failure to follow all instructions listed below may
Result in electric shock, fire, and/or serious injury.
Strictly prohibit disassembling this device without authorization.
Strictly prohibit placing this device near high magnetic field,
which will damage it and make it can’t work well.
Strictly prohibit making the device exposed to the rain or
becoming damp, which will cause interior short circuit and make
the battery emit heat, smoke, be out of shape, damage or even
explode.
This device has large current discharge characteristic; please
prevent children from operating or playing it.
Please fix this device well when placed in the back of a car to
avoid affect drive safety.
This device is battery products so you’d better charge it once
within 3 month or change it once in half a year at least to extend
the working life of lithium batteries.
Strictly prohibit throwing this device in fire, which will cause
blast.
SAVE THESE INSTRUCTIONS
Please deal with the scrap device according to related rule.
Please not store the built-in battery as house refuse,
which will cause blast and pollution.
CAUTION:
1. The unit only can be used for jump-start car in emergency;
it can’t replace the car battery.
2. Please connect the alligator clip to car battery correctly:
red to red and black to black.
3. When Voltage of the built in lithium battery is lower than the
lowest Voltage to start-jump a car, the unit can’t work.
4. When the car battery voltage is lower than 3V, the unit will treat
the car battery as bad one and can’t start automatically.
5. When you disconnect the unit and the car battery, please try to
prevent the positive and negative touching otherwise there would
be spark causing potential safety hazard. If you connect the
positive and negative unconsciously, the unit will power-off
automatically.
6. Please choose the right mode for your car.
h
1. PRODUCT INTRODUCTION
Diagram 1: Front and bottom side description
1. /MODE
2. USB Output
3. LED Light
4. Battery Capacity indicator
5. Micro USB Charging input
6. DC 12V Charging input
7. Micro USB Output
8. EC 5 Output
9. Dust Cover
2. KEY AND FUNCTION DESCRIPTION
/MODE: Power Switch /LED light mode select
Power ON: Please press the key
unit. After starting up the unit, the battery capacity indicator will be
light up and if no device connects to the unit, it will be power-off
automatically.
LED light mode select: Please press
(about 3 second) open the LED working light, press the key shortly
then you can choose 3 mode: White Light /Traffic Fault
Warning/SOS .You can shut down LED light function by press the key
for 3 seconds.
/MODE shortly to power ON the
/MODE for a long time
Mode Description
White Light Illumination means white LEDs keep lighting.
Traffic Warning light means Red LED and Blue LED keep flash
SOS means white LEDs keep flash for 3 short time-3 long time -
3 short time.
3. HOW TO JUMP START YOUR CAR
Warning: Jump-starting a car can cause serious
injury if you are not careful. If you are unsure of what you
are doing at any point, do not attempt to jump-start your
car. Call your friendly roadside towing service for help
instead.
When your car engine can’t be started because of car battery lower
voltage or lower temperature, you can use this unit to start your car
as the following steps:
Step 1：Open the DUST Cover
Step 2：Insert alligator to clamps terminal into EC5 output port
Step 3：Hook up the two jumper cable clamps —
red for positive and black for negative
Step 4：Start your car.
Note: If your connection is inverse or unreliability, the unit cannot
work.
Diagram 2: EC5 output clamps connect with car battery
1. When there is weak current in the battery of car, user charges the
car battery with the jump starter power bank, the red LED will light up.
When car engine starts working, LED will light off after 1 sec, it
means, the power bank stops delivering any current to the battery in
car any more. It will protect car not to be damaged by the current
from power bank continually.
2. When there is no any current in the battery of car, user charges the
car battery with the jump starter power bank, the red LED won't light
up. Then user has to press the button. The LED lights up will
continue for 30 seconds. Within 30 seconds user has to jump start
the car. When car engine starts working, LED will light off after 1 sec,
it means, the power bank stops delivering any current to the battery
in car any more. It will protect car not to be damaged by the current
from power bank continually.
4. HOW TO USE DISCHARGING AND CHARGING
FUNCTION
Unit discharging from USB output:
1. The unit built in Micro USB output cable, Please use it charging
your MP3, mobile, or others portable device.
2. The unit built in Type A USB output port, output max 5V/2.1A current
to charge for standard USB portable devices.
Note: It is the best charging effect to charge your device by your own
original USB cable.
Unit charging:
The unit support Micro USB 5V/1A and DC 12V /1A charging input,
please select corresponding cable to charging the unit.
Note: Don’t use Micro USB 5V/1A and DC 12V /1A charging the unit
at same time to avoid damaging the unit.
5. TECHNICAL PARAMETERS
Battery Capacity 9000mAh, Li-polymer
Cycle life >300 times
USB output USB: 5V/2.1A (max), 33,3Wh
Micro USB: 5V/1A
EC5 output
DC charging input DC: 12V/1A Micro USB: 5V/1A
Charging time DC 12V: ~4-5h
Micro USB: ~9-10h
LED light power White: 1W Red: 1W Blue: 1W
Working
temperature
Storage
temperature
Net weight 380g
Unit size (LXWXH) 145x72x28mm
8-12V/90A Duration Power
300A (max) Peak Cranking Power
(12V @ 1A charging current)
(5V @ 1A charging current)
-20℃-60℃
-20℃-60℃
Loading...