Edimax Technology Co 9574381406 Users Manual
300N Wireless Range Extender
User Manual
Version: 1.0
(May, 2014)
COPYRIGHT
Copyright ©2011/2012 by this company. All rights reserved. No part of this
publication may be reproduced, transmitted, transcribed, stored in a retrieval
system, or translated into any language or computer language, in any form or
by any means, electronic, mechanical, magnetic, optical, chemical, manual or
otherwise, without the prior written permission of this company
This company makes no representations or warranties, either expressed or
implied, with respect to the contents hereof and specifically disclaims any
warranties, merchantability or fitness for any particular purpose. Any software
described in this manual is sold or licensed "as is". Should the programs prove
defective following their purchase, the buyer (and not this company, its
distributor, or its dealer) assumes the entire cost of all necessary servicing,
repair, and any incidental or consequential damages resulting from any defect
in the software. Further, this company reserves the right to revise this
publication and to make changes from time to time in the contents thereof
without obligation to notify any person of such revision or changes.
Federal Communication Commission
Interference Statement
FCC Part 15
This equipment has been tested and found to comply with the limits for a Class
B digital device, pursuant to Part 15 of FCC Rules. These limits are designed
to provide reasonable protection against harmful interference in a residential
installation. This equipment generates, uses, and can radiate radio frequency
energy and, if not installed and used in accordance with the instructions, may
cause harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation. If this
equipment does cause harmful interference to radio or television reception,
which can be determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more of the following
measures:
1. Reorient or relocate the receiving antenna.
2. Increase the separation between the equipment and receiver.
3. Connect the equipment into an outlet on a circuit different from that
to which the receiver is connected.
4. Consult the dealer or an experienced radio technician for help.
FCC Caution
This equipment must be installed and operated in accordance with provided
instructions and a minimum 20 cm spacing must be provided between
computer mounted antenna and person’s body (excluding extremities of hands,
wrist and feet) during wireless modes of operation.
This device complies with Part 15 of the FCC Rules. Operation is subject to the
following two conditions: (1) this device may not cause harmful interference,
and (2) this device must accept any interference received, including
interference that may cause undesired operation.
Any changes or modifications not expressly approved by the party responsible
for compliance could void the authority to operate equipment.
Federal Communication Commission (FCC) Radiation Exposure
Statement
This equipment complies with FCC radiation exposure limits set forth for an
uncontrolled environment. In order to avoid the possibility of exceeding the
FCC radio frequency exposure limits, human proximity to the antenna shall not
be less than 20cm (8 inches) during normal operation.
The antenna(s) used for this transmitter must not be co-located or operating in
conjunction with any other antenna or transmitter.
The equipment version marketed in US is restricted to usage of the channels
1-11 only.
R&TTE Compliance Statement
This equipment complies with all the requirements of DIRECTIVE 1999/5/EC
OF THE EUROPEAN PARLIAMENT AND THE COUNCIL of March 9, 1999 on
radio equipment and telecommunication terminal Equipment and the mutual
recognition of their conformity (R&TTE).
The R&TTE Directive repeals and replaces in the directive 98/13/EEC
(Telecommunications Terminal Equipment and Satellite Earth Station
Equipment) As of April 8, 2000.
Safety
This equipment is designed with the utmost care for the safety of those who
install and use it. However, special attention must be paid to the dangers of
electric shock and static electricity when working with electrical equipment. All
guidelines of this and of the computer manufacture must therefore be allowed
at all times to ensure the safe use of the equipment.
EU Countries Intended for Use
The ETSI version of this device is intended for home and office use in Austria,
Belgium, Denmark, Finland, France, Germany, Greece, Ireland, Italy,
Luxembourg, the Netherlands, Portugal, Spain, Sweden, and the United
Kingdom.
The ETSI version of this device is also authorized for use in EFTA member
states: Iceland, Liechtenstein, Norway, and Switzerland.
EU Countries Not intended for use
None.
C A T A L O G
Chapter I: Product Information .................................................................... 1
1-1 Introduction and safety information ............................................................. 1
1-2 Safety Information ....................................................................................... 2
1-3 System Requirements .................................................................................. 3
1-4 Package Contents ........................................................................................ 4
1-5 Familiar with your new wireless repeater ..................................................... 5
CHAPTER II: Setup your Range Extender ............................................... 8
2-1 First time setup your Range Extender .......................................................... 8
2-1-1 Repeater mode setup ......................................................................... 9
2-1-2 AP mode setup ................................................................................ 14
2-1-3 Client mode setup ........................................................................... 17
2-2 Advanced setup ......................................................................................... 20
2-2-1 WPS Setting ................................................................................... 20
2-2-2 Advance Settings ............................................................................ 21
Chapter X: Appendix ................................................................................ 24
5-1 Configuring TCP/IP on PC ........................................................................ 24
5-1-1 Windows XP IP address setup: ........................................................ 24
5-1-2 Windows Vista/Windows 7 IP address setup: ................................... 25
5-2 Specification .............................................................................................. 28
5-3 Glossary .................................................................................................... 29
Chapter I: Product Information
1-1 Introduction and safety information
Thank you for purchasing this mini 802.11b/g/n wireless range extender!
The ultra-compact design with power built-in allows you to install this repeater
everywhere, and still providing excellent network performance to extend the Wi-Fi
signal and wireless coverage.
Other features of this wireless repeater including:
Extend the wireless signal inside your home or office.
Ultra-compact design while maintaining excellent network performance.
LED signal indicator to easily realize the best location placement to extend
WiFi signal and secure better wireless performance.
This device can support Repeater, AP and client modes.
WPS (Wi-Fi Protected Setup) hardware button for easy installation and
secure wireless security.
1
1-2 Safety Information
In order to keep the safety of users and your properties, please follow the following
safety instructions:
1. This wireless repeater is designed for indoor use only. DO NOT expose this device
to direct sun light, rain, or snow.
2. DO NOT put this at or near hot or humid places, like kitchen or bathroom. Also, do
not left this Wireless repeater in the car in summer.
3. Do not allow kids to put any small parts of this wireless repeater in their mouth,
and it could cause serious injury or could be fatal. If they throw this wireless
repeater, it will be damaged. PLEASE KEEP THIS WIRELESS REPEATER OUT
THE REACH OF CHILDREN!
4. This Wireless repeater will become hot when being used for long time (This is
normal and is not a malfunction). DO NOT put the Wireless repeater on a paper,
cloth, or other flammable objects after the Wireless repeater has been used for a
long time.
5. There’s no user-serviceable part inside the Wireless repeater. If you found that the
Wireless repeater is not working properly, please contact your dealer of purchase
and ask for help. DO NOT disassemble the Wireless repeater by yourself, warranty
will be void.
6. If the Wireless repeater falls into water, DO NOT USE IT AGAIN BEFORE YOU
SEND THE CARD TO THE DEALER OF PURCHASE FOR INSPECTION.
2
1-3 System Requirements
Wireless network card which is compatible with 802.11b/g/n wireless network
standard.
Windows 2000, 2003, XP, Vista, 7 or Windows 8/8.1 operating system
CD-ROM drive
At least 100MB of available disk space
3
1-4 Package Contents
Before you start to use this Range Extender, please check if there’s anything missing
in the package, and contact your dealer of purchase to claim for missing items:
□ Range Extender (1 set)
□ Quick Installation Guide (1 set)
□ User Manual CDROM (1 disc)
4
1-5 Familiar with your new wireless repeater
B C
Interface Descriptions
A
Item Item Name Description
A Mode switch
B LAN port
C WPS / Reset button
You can switch the operation mode by this switch,
this Range Extender supports 3 modes, include AP
mode, Repeater mode and Client mode.
One 10/100Mbps Ethernet LAN Port with
Auto-MDI/MDI-X. Connecting to computer, switch
or other device for network.
This button support 2 functions:
1. One click to start WPS function (Both 2.4Ghz
and 5Ghz)
2. Hold the button 10 seconds to reset all the values
to the factory default.
5
LED Definitions
and system is boot
,
,
for 2
LED Color LED Status Description
Steady ON 1. Good signal (RSSI 100%~50%)
Signal
Status Green
WLAN
Status
Power
On/Off
Status
WPS
Status
Green
Green
Green
1. Poor signal
Blinking
Off 1. No signal
Blinking
Off Wireless network is switched off
Steady ON
Slow Blinking
Off 1. Power is turned off.
Steady ON
Blinking
2. Slow blinking (RSSI <50%~25%)
3. Quick blinking (RSSI <25%)
Wireless function is active (transferring or
receiving data)
1. Power is turned on
up.
1. System is booting up.
2. Ready for “ Reset to factory default ”
power LED is blinking.
1. When WPS connection is successful
turn on for 5 minutes.
1. WPS is in progress, blinking
minutes (waiting for WPS connection)
LAN Green
Quick blinking 1. WPS error, blinking
Steady ON 1. LAN port is connected.
6
Loading...