Edimax Technology Co 9562201605 Users Manual

IC-6220DC

Quick Installation Guide

05-2016 / v1.0

Package Contents

Antenna

Camera Viewer

Gateway

QIG

Power

Adapter

Ethernet

Cable

Camera Battery Unit

Installation Kit: A

Installation Kit: B

Installation Kit: C

Do not remove the sticker from the camera viewer until the bolt has been
installed through your peep hole.

2

Reset

If you experience problems with your network camera, you can reset the
camera back to its factory default settings. This resets all settings back to
default.

Press and hold the Reset button on the back panel for at least 10 seconds.
Release the button when the power LED is flashing quickly green, and wait a
couple of minutes for the unit to restart.

3

LED Status

LED

LED Color

LED Status

Description

Power

Green

On

Gateway is on and connected to
cloud server.

Quick Flashing

Gateway is restarting.

Slow Flashing

Gateway is starting up or is not
connected to cloud server.

LAN

Green

On

Gateway is connected to the
local network.

Quick Flashing

LAN activity (transferring data).

Internet

Orange

On

Connected to Internet.

Quick Flashing

Gateway is restarting.

Slow Flashing (1 x

per second)

Not connected to Internet.

LED

LED Color

LED Status

Description

Status

Green

On

Camera is on and connected to
cloud server.

Orange

Slow Flashing

PIR motion detection trigger.

Battery

Red

Flashing

Low battery warning.

Gateway:

Camera:

The camera’s Status LED displays off when the camera is switched on but

not in use.

4

Setup

The door camera unit mounts conveniently and securely to your door’s

peephole. Carefully remove any existing viewer/cover on your peephole
before you begin.

1. Screw on the included antenna to the gateway unit and connect the power

adapter. The green power LED will flash slowly when the gateway is ready.

2. Use an Ethernet cable to connect the gateway to your wireless router or

access point. The green power LED and orange Internet LED will display on
to indicate successful cloud and Internet connections.

3. Twist to remove the cover and insert 4 x AA batteries into the camera

battery unit.

Alkaline batteries are recommended for longer battery life.

5

4. To remove an existing peephole from your door, you can usually simply

unscrew it using a coin.

5. Remove the warning sticker from the camera viewer.

6. Remove the sticker from the black double-sided tape on the camera

viewer.

6