PrintSir Plus
PS-1100+ v2.0
1-Port 10/100Mbps
Palmtop Print Server
User’s Manual
n Hardware Installation
n Features and Specifications
Print Server
This equipment generates and uses radio frequency energy and if not
installed and used properly, that is, in strict accordance with the
instructions provided with the equipment, may cause interference to
radio and TV reception. The equipment has been tested and found to
comply with the limits for a Class A computing device in accordance
with the specifications in Subpart B of Part 15 of FCC rules, which are
designed to provide reasonable protection against such interference in a
commercial environment. However, there is no guarantee that
interference will not occur in a particular installation.
If you suspect this equipment is causing interference, turn your print
server on and off while your radio or TV is showing interference to
determine the source of the interference.
You can try to correct the interference by one or more of the following
measures:
1. Reorient the receiving radio or TV antenna where this may be done
safely.
2. To the extent possible, relocate the radio, TV or the other receiver
away from the equipment.
3. Plug the computer which has the equipment installed into a different
power outlet so that equipment and the receiver are on different
branch circuits.
If necessary, you should consult the place of purchase or an experienced
radio/ television technician for additional suggestion.
CAUTION : The phone jack cannot be connected to telephone system.
FCC COMPLIANCE STATEMENT
1
Thanks for purchasing this Fast Ethernet Print Server - PS-1100+. This
guide explains its external features, explains how to unpack your Print
Server hardware, and tells how you can connect it to your printer and to
your network.
Requirements
To use your PS-1100+, you will need :
Ÿ A Printer with parallel interface.
Ÿ Ethernet network cabling, as well as a free 10Base-T hub; or Fast
Ethernet network cabling, as well as a free 100Base-TX hub.
Unpacking the Print Server
When you unpack your PS-1100+, you should find :
Ÿ One Print Server with one parallel printer connector.
Ÿ One power adapter, with an input voltage appropriate for your area.
Ÿ One 3.5 inch software diskette containing the “Print Server Utilities for
DOS” program.
Ÿ One 3.5 inch software diskette containing the “Print Server Utilities for
Windows 95/98/NT” program.
Ÿ One 3.5 inch software diskette containing the “Print Server LPR Print
Driver for Windows 95/98” program.
Ÿ One 3.5 inch software diskette containing the “Print Server WEB
Management Utility for Windows 95/98/NT” program.
Ÿ One User’s Manual for software installation and configuration.
Ÿ One User’s Manual for Hardware installation and features/specifications.
If any of the above items is missing or damaged, contact your dealer
immediately.
Hardware Installation
2
Loading...