Edimax IC-6220DC Installation Manual
IC-6220DC
Quick Installation Guide
11-2020 / v1.2
Antenna
Camera Viewer
Gateway
QIG
Power
Adapter
Ethernet
Cable
Camera Battery Unit
Installation Kit: A
Installation Kit: B
Installation Kit: C
Extension Bolts
CD
Alkaline Battery
Package Contents
Do not remove the sticker from the camera viewer until the bolt has been
installed through your peep hole.
Reset
If you experience problems with your network camera, you can reset the
camera back to its factory default settings. This resets all settings back to
default.
Press and hold the Reset button on the back panel for at least 10 seconds.
Release the button when the power LED is flashing quickly green, and wait a
couple of minutes for the unit to restart.
3
LED Status
LED
LED Color
LED Status
Description
Power
Green
On
Gateway is on and connected to
cloud server.
Quick Flashing
Gateway is restarting.
Slow Flashing
Gateway is starting up or is not
connected to cloud server.
LAN
Green
On
Gateway is connected to the
local network.
Quick Flashing
LAN activity (transferring data).
Internet
Orange
On
Connected to Internet.
Quick Flashing
Gateway is restarting.
Slow Flashing (1 x
per second)
Not connected to Internet.
LED
LED Color
LED Status
Description
Status
Green
On
Camera is on and connected to
cloud server.
Orange
Slow Flashing
PIR motion detection trigger.
Battery
Red
Flashing
Low battery warning.
Gateway:
Camera:
The camera’s Status LED displays off when the camera is switched on but
not in use.
4
Door Thickness
For doors with thickness 55 – 90mm there are two included extension bolts to
enable the camera viewer to fit your door. Either of the extension bolts can
replace the original bolt that’s attached to the unit.
The smaller bolt is for door thickness 55 – 75mm.
The longer bolt is for door thickness 75 – 90mm.
To use an extension bolt:
1. Remove the plastic tube from the camera viewer’s bolt. The cable inside
the plastic tube will fall loose.
2. Hold the lens in place and unscrew and remove the original bolt that’s
currently attached.
Make sure you hold the lens in place while you unscrew the bolt,
otherwise the lens will fall out.
3. Screw on the extension bolt for your door thickness, replace of the original
bolt.
4. Slide the plastic tube back on to the bolt, with the cable inside. The cable
must be routed through the plastic tube as you slide the tube back on.
5. Follow the Setup procedure from the beginning, as explained in the next
chapter.
Setup
The door camera unit mounts conveniently and securely to your door’s
peephole. Carefully remove any existing viewer/cover on your peephole
before you begin.
1. Screw on the included antenna to the gateway unit and connect the power
adapter. The green power LED will flash slowly when the gateway is ready.
2. Use an Ethernet cable to connect the gateway to your wireless router or
access point. The green power LED and orange Internet LED will display on
to indicate successful cloud and Internet connections.
3. Twist to remove the cover and insert 4 x AA batteries into the camera
battery unit.
Alkaline batteries are recommended for longer battery life.
5
Loading...