Edimax ES-1008PH V2 operation manual

ES-1008PH V2 /GS-1008PH V2

Quick Installation Guide

02-2017 v1.0

Model No.

QIG

Power Cord

PoE+ Switch

Rack-Mount Kit

ES-1008PH V2: 8-Port Fast Ethernet Switch with 4 PoE+ Ports
GS-1008PH V2: 8-Port Gigabit Switch with 4 PoE+ Ports

Package Contents

Before you start using this product, please check if there is anything missing in
the package, and contact your dealer to claim the missing item(s):

I-2. Hardware Overview

Front Panel:

Please refer to the following description for the front panel:

ES-1008PH V2

GS-1008PH V2

DIP Switch Definition:

DIP Switch

Status

Description

1

(Extend)

On

This mode makes the PoE Port 1~2
operate at auto-negotiation 10Mbps
speed duplex mode only, but the
delivery distance of PoE power and
network data can reach 200m.

Off
(default)

This mode makes the PoE Port 1~2
operate as a genral switch.

2

(Extend)

On

This mode makes the PoE Port 3~4
operate at auto-negotiation 10Mbps
speed duplex mode only, but the
delivery distance of PoE power and
network data can reach 200m.

Off
(default)

This mode makes the PoE Port 3~4
operate as a genral switch.

3

(VLAN)

On

This mode makes the PoE+ switch
operate as a VLAN isolation switch
and port 1 to port 4 will isolate
respectively., port 1 to port 4 can only
communicate with port 5 (uplink
port).

Off
(default)

This mode makes the PoE+ switch
operate as a genral switch.

4

(QoS)

On

This mode makes the PoE+ switch
operate as a QOS switch, it follows the

802.1p QoS, video and voice with high
priority.

Off
(default)

This mode makes the PoE+ switch
operate as a genral switch.

The front pnael of PoE+ switch provies four pins DIP Switch. The detailed

descriptions are shown nin the following table.

Please note, after truning ON the DIP switch you will have to Reboot the
switch.