EDI P103 M7 Backup Datasheet

Performance Controls

Features

• 24" rack mount

• Simple user assignable controls

• Available in 60 or 120 channel capacities

• Signal light indicates data signal in process

• Overtemp signal light

Calibration Adjustments Status Indicators Analog Backup

• Power phase indicator lights

• Supports USITT DMX-512 Digital, AMX 192, RS422, fiber-optic or 0 - +10 VDC Ana-

log inputs

• Simultaneous processing of digital and analog signals

Mark VII Analog Backup

Description

Analog Backup provides easy access and control of user assignable groups of lights or dimmers. This allows easy access to presets by general
users without requiring a complete working knowledge of the control console.

Analog Backup offers a simple 10-channel control matrix. A single dimmer or group of dimmers can be assigned to a control channel by means of
a wire pin matrix patch. Commonly controlled dimmer groups can be assigned to ten slide potentiometers with a master and On/Off control located
at the Stage Manager's panel.

Specifications

1. The plug-in control module shall be a self-contained unit which will
slide into the front of the dimmer bank.

2. The control module shall properly receive USITT DMX-512 digital
multiplex, AMX-192 analog multiplex, or RS422 digital multiplex,
fiber optic or 0-10 Volt analog signals. Digital signals shall termi­nate in 5-pin XLR-type connectors. Fiber optic transmissions shall
terminate in an optical coupler. Analog controls shall terminate in a
25-pin D-style connector. The multiplex format may be changed by
a single front-panel mounted switch.

3. A yellow indicator shall illuminate upon receipt of a valid digital
signal. A momentary interruption of a digital signal shall not affect
dimmer output.

4. The dimming system shall be able to operate simultaneously on a
multiplex signal and analog 0-10 volt signal. The analog signal
shall activate the backup matrix patch of independently assigned
dimmers to the selected intensities set by the controller. Should the
DMX signal ports fail, the analog backup shall operate as a stand­alone controller. The analog backup shall have the capacity for
multiple input on a highest-takes-precedence basis. Systems elec­tronics without this capacity shall not be considered equal.

5. The module shall illuminate a pilot light for each power phase dur­ing operation. Input power to the control module shall be breakered
and fused.

6. All dimmer control electronics shall be contained on a double­sided, through-hole plated fiberglass circuit board.

7. The control module shall be a labeled, recognized component of
Underwriters Laboratory.

8. The unit shall be the Multi-Link series as manufactured by Elec­tronics Diversified, Inc., Hillsboro, Oregon 97214.

Riser Diagram

Dimmer Bank

Analog Backup

Data Line to
Control

RCC (5XLR)

Stage Manager’s Panel

(10 Channel Control Station)

Analog (15D)

Booth Control Console

Job Number: Customer: Approval Stamp:
Job Name: P.O.:

Electronics Diversified, Inc. PRODUCT DATA SHEET
1675 N.W. Cornelius Pass Road l Hillsboro, Oregon 97124 U.S.A. P103

Phone: [phone] l FAX: [phone] l Web Site: www.edionline.com

Specifications subject to change without notice. Specification applicable to standard products
only. ©1998 Electronics Diversified, Inc. All rights reserved. Printed in USA. 0703