Edgewater Networks 4562, 4610W Quick Start Manual

4562 Converged
Networking Router

Quick Start Guide

Version 1.0

Page 1 of 7

200-4562-001

Please read this guide thoroughly as it describes the basic installation of
the device. Additional configuration needed to deploy the device in a
specific environment can be performed with the help of online help.

This guide also provides an example of a typical 4562 deployment that
can be used as a guideline for your installation.

Requirements for Installation

• A computer with a web browser such as Microsoft Internet Explorer or
Netscape Navigator or any other browser of your choice

Before You Start

• At least one Ethernet cable

• Following information supplied by the VoIP Service Provider

o IP address of the WAN interface
o if T1 is being used for WAN connection then:

 T1 frame format
 Layer 2 protocol such as PPP, Frame Relay/DLCIs, HDLC,

etc.

o IP address of the Softswitch

Page 2 of 7

Step 1 − Connecting the Cables

Instructions

1. Connect one end of an Ethernet cable to local LAN port 4 of 4562. This port can be seen
in the area “B” of the above diagram. Connect the other end of the cable to your
computer’s Ethernet port.

2. If T1 is used for the WAN connectivity then perform the following steps, otherwise go to

5.

step

Page 3 of 7