Edgewater Networks 4300T Series Quick Start Manual

4300T Series

Converged Network Appliance

Quick Start Guide

This guide helps you to install and connect to the 4300T Series

converged network appliance. You may then use the online

help files to configure the 4300T to meet the specific needs of

your environment.

This guide also provides an example of a typical 4300T Series

deployment that can be used as a guideline for your

installation.

Before you begin you must have:

o A computer with a web browser (Microsoft Internet Explorer or

Netscape Navigator)

o At least 1 ethernet cable
o The following information supplied by your VoIP service provider

 IP address of the WAN interface
 T1 frame format
 Layer 2 protocol (PPP, Frame Relay/DLCIs or HDLC)
 IP address of the Softswitch

,

Step 1 – connect all of the cables

• Connect an ethernet cable between LAN port 4 on the 4300T and your
computer’s ethernet port.

• Connect a cable between the T1/E1 WAN port on the 4300T and the T1
demarcation unit provided by your service provider. Alternatively, connect an
ethernet cable between the WAN ethernet port on the 4300T and a WAN
router or broadband modem.

• Plug one end of the power adapter into an AC outlet and the other end into

CAUTION: To reduce the risk of fire, use only 26 AWG or larger wire (e.g.
24

22, 20, etc.) to connect the T1 port on your unit to an RJ-45 jack.

the power receptacle on the 4300T.