Edge Lighting Vision 3 User Manual

© 2010 Edge Lighting. All Rights Reserved.

1718 W. Fullerton Ave

Chicago, IL 60614

Tel: [phone]

Fax: [phone]
www.edgelighting.com
[e-mail]

VISION3-KIT-H1-_

Installation Instructions for Vision 3 Halogen Kit

IMPORTANT SAFETY INSTRUCTIONS

To reduce the risk of fire, electrical shock, exposure to
excessive UV radiation, or injury to persons:

- Use this fixture indoors only.

- Do not look directly at the lamp while the fixture is on.

- RISK OF FIRE: Use only the type of lamp and maximum
wattage indicated in this instruction manual.

- Never cover the halogen lamp with anything other than a
lamp shield provided by Edge Lighting and never place
flammable material close to the fixture.

- Never turn the fixture on and off by connecting and
disconnecting the halogen lamp.

- Do not touch the fixture head, shade or lamp shield while
the fixture is on. These surfaces may be VERY HOT.

- Do not touch lamp at anytime. Use a soft cloth instead as oil
from skin may damage lamp.

- It is normal for a new halogen lamp to produce minor
smoke when first turned on.

- Turn power off and allow to cool before replacing lamp.

IMPORTANT INFORMATION

- This product is ETL listed for indoor dry locations.

- This product is wall mounted only.

- This product can be dimmed with an electronic low voltage
dimmer.

SAVE THESE INSTRUCTIONS!

904-VISION3-KIT-H1-01

Install the Vision Housing

A

5

#8 SCREW

4

3

FOLDED LIP

1

PLASTER
SCREEN

STUD

NOTE: One of the housing lips needs to be installed to the

nearest stud of the desired location.

Mark the location on the stud where the housing will be

1:
mounted.

2: Place the plaster screen in front of the housing so that the
folded lips face outside.

3: Line up the screw holes on the plaster screen with the screw
holes of the housing and place one housing lip against the
marked stud.

4: Secure the housing along with the plaster screen to the stud
with the provided three #8 screws.

5: Use the other three #8 screws to secure the plaster screen
to the housing.

HOUSING LIP

1

B

HOUSING

CONDUIT

THERMAL
PROTECTOR

9

10

7

STUD

6: Remove a knock out to install the power line conduit.

7: Install the conduit and run the power line wires to the

housing.

8: Make sure that the housing is grounded in accordance with
local electrical codes.

9: Connect the white transformer wire to the neutral power
line wire with a wire nut.

10: Connect the black thermal protector wire to the hot power
line wire with a wire nut.

11: The black transformer wire is connected by default to the
other wire of the thermal protector.

7

TRANSFORMER

1: Mark 3" square(s) on drywall where the housing opening is
(are) located.

2: Cut out the marked square(s) and install the drywall.

D

TERMINAL
BLOCK

STRAIN RELIEF

DRYWALL

1

4

5

8

Install Drywall, Trim & Lamp

C

1

2

3: After installing drywall and finishing it, remove the cover on

the terminal block to expose the screws.

4: Loosen the two left Phillips screws on the terminal
block and the two on the strain relief (Do Not Remove).

5: Insert blue transformer wire through the strain relief
and one into each terminal block hole. Tighten the Phillips
screws on the terminal block and strain relief.

6: Replace the terminal block cover.

3"

3"

TRIM

COVER

2