Edge Lighting Vessel 6 User Manual

1718 W. Fullerton Ave

Chicago, IL 60614

Tel: [phone]

Fax: [phone]

www.edgelighting.com

© 2013 Edge Lighting. All Rights Reserved.

[e-mail]

Installation Instructions for Vessel 6 Suspension

IMPORTANT INFORMATION

- This product can ONLY be ceiling mounted.

- This product can mount to either a 4" square electrical box
with round plaster ring or an octagon electrical box.

SAVE THESE INSTRUCTIONS!

Install the Fixture

VESS-S-6-WH

904-VESS-S-6-01

A

2: Insert the cord into the strain relief, canopy, and crossbar

assembly.

3: Adjust the fixture height, and mark a line when the desired
height is achieved.

CANOPY

H

1

SHADE

C

CANOPY

WIRES

INSULATION

CORD

1: Determine the desired fixture height (H), from the bottom of
the shade to the top the canopy.

B

4: Leave 6" of the crossbar assembly behind the canopy for

power connections. Cut the excess cord.

5: From the end of the cord remove 4" of the cord
fabric/insulation. Make sure not to nick the inner

wires and trim off the cutout insulation.

6: Strip 1/4" of the insulation from the end of the wires.

MARK LINE

CROSSBAR
ASSEMBLY

CANOPY

STRAIN RELEIF

3

2

CORD

FABRIC

CORD DETAIL

4"

5

6"

4

1

D

ELECTRICAL
BOX

Make sure that the canopy is grounded in accordance

7:

with local electrical codes.

7

9

8

CROSSBAR
ASSEMBLY

CANOPY

STRAIN RELIEF

10: Place all wire and wire nut connections inside the electrical
box.

11: Mount the crossbar assembly to the electrical box holes
with the provided #8-32 screws.

F

ELECTRICAL
BOX

8: Connect the fixture blue wire to the neutral power wire
with a wire nut.

9: Connect the fixture brown wire to the hot power wire with
a wire nut.

E

10

11

CANOPY

STRAIN RELIEF

ELECTRICAL
BOX

CROSSBAR
ASSEMBLY

#8-32
SCREWS

12: Slide the canopy into the crossbar assembly nipple and
secure using the strain relief.

CROSSBAR
ASSEMBLY
NIPPLE

PLASTIC
SCREW

13

12

CANOPY

STRAIN RELIEF

CORD

CAUTION: To reduce risk of a burn or electrical shock during

lamping, disconnect the power to the fixture.

Use MAX 40 Watt Type E14 base, torpedo style
candelabra lamp.

14: Screw the lamp completely into the socket.

13: Slightly tighten the plastic screw on the strain relief to avoid

the cord from sliding down.

G

SOCKET

14

LAMP

SHADE

2