Edge Lighting Vessel 10 User Manual

1718 W. Fullerton Ave

Chicago, IL 60614

Tel: [phone]

Fax: [phone]

www.edgelighting.com

© 2013 Edge Lighting. All Rights Reserved.

[e-mail]

Installation Instructions for Vessel 10 Suspension

IMPORTANT INFORMATION

- This product can ONLY be ceiling mounted.

- This product can mount to either a 4" square electrical box
with round plaster ring or an octagon electrical box.

SAVE THESE INSTRUCTIONS!

Install the Fixture

VESS-S-10-_

904-VESS-S-10-01

A

CANOPY

H

1

SHADE

Loosen the threaded cap, to expose the crossbar assembly

2:

and also entangle the cord from the cord clip.
Do Not Dissemble, Keep Parts in Order.

C

CORD CLIP

1: Determine the desired fixture height (H), from the bottom of
the shade to the top the canopy.

B

CORD CLIP

2

CROSSBAR
ASSEMBLY

2

CANOPY

THREADED CAP

3: Adjust the fixture height by sliding the cord up or down
through the crossbar. Make a line behind the crossbar
assembly when desired height is determined.

CROSSBAR
ASSEMBLY

MARKED LINE

CANOPY

THREADED CAP

3

1

D

CROSSBAR
ASSEMBLY

CANOPY

4: Place the cord clip 1" above the marked line by feeding

CORD CLIP

1"

4

the cord through the second hole on the cord clip and
pulling it out to lock in place.

E

THREADED CAP

5: Leave 6" of the cord behind the crossbar assembly for
power connections. Cut the excess cord.

6: From the end of the cord remove 4" of the cord
insulation.

7: Strip 1/4" of the insulation from the end of the wires.

F

8

10

ELECTRICAL
BOX

9

CANOPY

THREADED
CAP

Make sure that the canopy is grounded in accordance

8:

with local electrical codes.

9: Connect the fixture white wire to the neutral power wire
with a wire nut.

10: Connect the fixture black wire to the hot power wire with
a wire nut.

CROSSBAR
ASSEMBLY

CORD CLIP

5

4"

6

CROSSBAR
ASSEMBLY

Place all wires and wire nut connections inside the

11:
electrical box.

12: Mount the crossbar assembly to the electrical box holes
with the provided two #8-32 screws.

13: Slide the canopy up onto the crossbar assembly and
secure it in place by tightening the threaded cap to the
crossbar assembly nipple.

G

11

12

ELECTRICAL
BOX

#8-32 SCREWS

CANOPY

13

THREADED CAP

2