Edge Lighting Vase User Manual

© 2014 Edge Lighting. All Rights Reserved.

1718 W. Fullerton Ave

Chicago, IL 60614

Tel: [phone]

Fax: [phone]
www.edgelighting.com
[e-mail]

FJ-VASE1-_
FJ-VASE2-_

Installation Instructions for Fast Jack Vase Round and Square

IMPORTANT SAFETY INSTRUCTIONS

- Use this fixture indoors only.

- This product can be dimmed with a standard low-voltage
electronic dimmer.

- This product must be installed by a qualified electrician.

- Before beginning any electrical work, ensure that

power to the junction box is turned OFF.

SAVE THESE INSTRUCTIONS!

Install the Lamp

904-FJ-VASE-01

A

SOCKET

LED
BI-PIN
LAMP

1: Cut the coaxial cable to the desired height (H) with a sharp
cutter. The overall fixture height is measured from the
bottom of the glass shade to the end of the coaxial cable.

1

NOTE: Use MAXIMUM 3 Watt 12 VAC LED

Bi-pin lamp.

1: Push the LED lamp pins completely into the socket holes.

Adjust the Fixture Height

B

1

H

C

2MM ALLEN
WRENCH

M4 SET SCREW

2

COAXIAL FIXTURE
CONNECTOR

3

1.5MM ALLEN
WRENCH

M3 SET
SCREW

2: Loosen the M4 set screw on base of the coaxial fixture
connector with the 2mm Allen wrench provided. Do not

remove this set screw.
3: Remove the M3 set screw on tip of the connector with the

1.5mm Allen wrench provided.

1

D

CIRCUIT
#1

1
2
N

12

CIRCUIT
#2

1
2
N

12

STRAIN RELIEF TUBE

4

4: Feed the coaxial cable through the conical nipple and flared

side of the strain relief tube. Slide the conical nipple and
strain relief tube down the coaxial cable.

E

COAXIAL CABLE

CONICAL NIPPLE

5: Feed the coaxial cable into the coaxial fixture connector. The
coaxial cable will come to a stop point.

F

1.5MM ALLEN WRENCH

M3 SET SCREW

WRINKLE

7
6

8

OUTER METAL JACK INNER WIRE

5

COAXIAL CABLE

6: Keep feeding the coaxial cable in until the inner wire is
visible in the screw hole of the fixture connector tip. The
outer metal jacket will start to wrinkle.

7: Hold the fixture connector in place. Replace and tighten the
M3 set screw on fixture connector tip with the 1.5mm Allen
wrench.

8: Pull down the outer metal jacket to smooth the wrinkles.

G

2MM ALLEN WRENCH

COAXIAL FIXTURE
CONNECTOR

9: Push the strain relief tube completely into the coaxial
fixture connector. Make sure the slot on the strain relief
tube is not inline with the M4 set screw.

10: Tighten the M4 set screw with the 2mm Allen wrench.

H

11: Use fingers to tighten the Fast Jack fixture connector into the Fast Jack system connector (Monorail, Monorail 2 Circuit, or

canopy connector - Refer to the instructions provided with the system connector or canopy).
12: Refer to the instructions provided with the Monorail 2 Circuit fixture connector to choose Circuit #1 or Circuit #2.

M4 SET SCREW

STRAIN RELIEF TUBE

11

11

11

11

11

11

10

9

2