Edge Lighting Vanilla Sky Square User Manual

© 2009 Edge Lighting. All Rights Reserved.

1718 W. Fullerton Ave

Chicago, IL 60614

Tel: [phone]

Fax: [phone]
www.edgelighting.com
[e-mail]

VSKY-SQ-14-F1-_

904-VSKY-SQ-14-F1-04

Installation Instructions for Vanilla Sky Square 14

Fluorescent Version)

IMPORTANT INFORMATION

- This product is ETL listed for indoor dry locations.

- This product is ceiling mounted only.

- This product can mount to either a 4" square electrical box
with round plaster ring or an octagon electrical box.

SAVE THESE INSTRUCTIONS!

Install the Fixture

1: R

A

MOUNTING
CROSSBAR

emove the two thumb nuts from the threaded studs and

detach the mounting crossbar from the fixture assembly.

(Compact

FIXTURE
ASSEMBLY

THUMB NUT

2: Mount the mounting crossbar to the electrical box holes with
the two provided #8-32 screws

C

MOUNTING
CROSSBAR

5

1

4

THREADED
STUD

4

B

MOUNTING
CROSSBAR

#8-32 SCREW

3: Make sure that the mounting crossbar is grounded in
accordance with local electrical codes.

4: Connect the white fixture wire to the neutral power wire with
a wire nut.

5: Connect the black fixture wire to the hot power wire with a
wire nut.

2

ELECTRICAL
BOX HOLE

2

FIXTURE ASSEMBLY

1

D

CEILING

THREADED
STUD

7

THUMB NUT

ELECTRICAL
BOX

6

6: Place all wires and wire nuts connections inside electrical box.

7: Align and push the canopy holes onto threaded studs and

tighten the thumb nuts completely to secure the canopy in
place.

E

Install the Lamp & Glass Shade

CAUTION:

lamping, disconnect the power to the fixture.

Use MAX 9 Watt Type 2G7 Base Compact
Fluorescent Lamp For Each Socket.

1: Push the lamp pins completely into the socket holes.

To reduce risk of a burn or electrical shock during

F

2

2

SPRING CLIP

SQUARE GLASS SHADE

LAMP

1

SOCKET

2: Place the two adjacent edges of the square glass shade into
two adjacent spring clips. Slightly push the glass shade
against these two spring clips and simultaneously slide the
other two edges into the other two spring clips. Make sure

all four edges of the glass shade sit properly into four
spring clips.

1

Replace the Lamp

2

1: While holding the glass shade unhook one spring clip at a

time until the glass shade is free.

2: Remove the old lamp and then follow "Install the Lamp &
Glass Shade" steps to complete lamp replacement.

G

1

SPRING CLIP

2

SQUARE GLASS SHADE

2

2