Edge Lighting Twin Slim LED - Dimmable User Manual

1718 W. Fullerton Ave

Chicago, IL 60614

Tel: [phone]

Fax: [phone]

www.edgelighting.com

© 2014 Edge Lighting. All Rights Reserved.

[e-mail]

Installation Instructions for Twin Slim LED

IMPORTANT INFORMATION

- This product is wall mounted only.

- Supply power to mirror in accordance with local electrical
codes.

- This instruction shows a typical installation

- This product is dimmable with ELV dimmers.

SAVE THESE INSTRUCTIONS!

Install the Mounting Plate

TWINSLIM-20-LED

904-TWINSLIM-20-LED-02

A

MIRROR

MOUNTING
PLATE

M6 SCREW

MIRROR

MOUNTING
PLATE

3: Align the mounting plate hole with the power line conduit, or
junction box. Use the mounting plate as a template to
mark eight mounting holes (highlighted in GREEN) onto the
wall.

NOTE: Make sure that the mounting plate is leveled horizontally.

1

2

NOTE: It is recommended that one person holds the mounting

plate while the electrician installs it.

1: Loosen and remove the four M6 screws on the top and
bottom of the mounting plate with the 3mm Allen wrench.

2: Pull the mounting plate completely out of the mirror.

B

ALIGN
CENTER
WITH
JUNCTION
BOX

MOUNTING
HOLE

3

3

H

4: Tap the anchors onto the marked points up to the threaded

WALL

4

ANCHOR

BE FLUSH TO WALL

5

ANCHOR MUST

portion with a hammer.

5: Screw in the threaded portion of the anchors with a Phillips
screwdriver.

1

D

#8-32
SCREW
(6X)

7

WALL

MOUNTING
PLATE

6: Feed the 120 VAC power wires through the mounting plate.

7: Line up the mounting plate holes with the anchors and

secure it with the eight #8-32 screws provided.

8: Ensure the mounting plate is grounded in accordance with
local electrical codes.

NOTE: Contains integrated 24V LED lights consuming a total of 40

Watts.

E

6

120 VAC
POWER
WIRES

9: Connect the 120VAC hot wire to the hot transformer wire
using a wire nut.

10: Connect the 120VAC neutral wire to the neutral transformer
wire using a wire nut.

F

M6 SCREW

12

9

11: Carefully place the mirror onto the mounting plate.

12: Secure the mirror to the mounting place by tightening four

M6 screws using an 3mm Allen wrench.

10

WIRE NUT

120VAC
POWER
WIRES

MIRROR

11

MOUNTING
PLATE

2