Edge Lighting Twin Slim Dimmable User Manual

1718 W. Fullerton Ave

Chicago, IL 60614

Tel: [phone]

Fax: [phone]

www.edgelighting.com

© 2012 Edge Lighting. All Rights Reserved.

[e-mail]

Installation Instructions for Twin Slim

IMPORTANT INFORMATION

- This product is ETL listed for indoor damp locations.

- Must be installed by a qualified electrician.

- This product is wall mounted only.

- Supply power to mirror in accordance with local electrical
codes.

- This instruction shows a typical installation

- This product is dimmable with a 0-10V dimmer.

SAVE THESE INSTRUCTIONS!

Install the Mounting Plate

TWINSLIM-20-F1-_

904-TWINSLIM-20-F1-05

A

MOUNTING HOLE

GNL

GNL

MOUNTING PLATE

POWER LINE

CONDUIT
HOLE

NOTE: The Twin Slim mirror mounts independently directly to

the wall without being supported by the electrical box, thus it is
recommended that one person holds the mounting plate while
the electrician installs it.

1: Align the mounting plate conduit hole with the power line
and use the mounting plate as a template to mark six
mounting holes onto the wall.

NOTE: Make sure that the mounting plate is leveled horizontally.

9/32 DRILL BIT

B

ANCHOR

WALL

2: Use a 9/32 drill bit to make holes on all six marked points.

3: Tap the anchors into the drilled holes with a hammer.

2

3

3

1

C

#8-32
SCREW

5

GNL

GNL

7

CONNECTOR

POWER LINE

4: Install the conduit connector (not provided) to mounting
plate hole. Feed the power line through the conduit
connector into the mounting plate.

5: Line up the mounting plate holes with the anchors and
secure it to the anchors with the six #8-32 screws provided.

6: Make sure that the mounting plate is grounded in
accordance with local electrical codes.

7: Connect the hot, neutral & ground power wires into the
wago connector.

NOTE: If necessary, push the tab down and then pull the Wago

connector for a quick disconnect.

NOTE: Omit steps 8 & 9 for non-dimming wiring.

8: For dimming, run the violet and gray wires from the dimmer

to the ballast. The wires must be solid copper (refer to the
dimmer instruction for more details).

9: Insert the violet wire to the (+) & the gray wire (-) ballast
terminal respectively.

Install the Lamp & Mirror

D

LAMP

9

BALLAST

VIOLET

GRAY

GREEN

WHITE

BLACK

(+) Dimming

(-) Control

G

N

L

8

WAGO
CONNECTOR

TAB

7

GNL

GNL

CAUTION: To reduce risk of a burn or electrical shock during

lamping, disconnect the power to the fixture.

Use MAX 24 Watt Type T5 HO,
Linear Fluorescent Lamp For Each Socket.

1: Line up the lamp pins on both sides with the opening on the
socket.

2: Insert the lamp pins all the way into the sockets and turn the
lamp to lock it in place. Repeat this step for the other lamp.

3: Place the mirror housing onto the mounting plate and secure
it in place by tightening the four #8 screw on the top
and bottom of the mirror housing into the mounting plate.

NOTE: NEMA fluorescent lamp manufacturers recommend to

reduce possible flicker or instability when new dimming systems
are comissioned, lamps should be operated at the ballast's
maximum light output setting overnight (approximately
12 hours).

SOCKET

MIRROR
HOUSING

1

3

3 3

GNL

GNL

2

3

GNL

GNL

MOUNTING PLATE

#8 SCREW

2