Edge Lighting Surface Mount Fast Jack Canopies User Manual

© 2009 Edge Lighting. All Rights Reserved.

1718 W. Fullerton Ave

Chicago, IL 60614

Tel: [phone]

Fax: [phone]
www.edgelighting.com
[e-mail]

FJP-4SF-LED-_

904-FJP-4SF-LED-01

Installation Instructions for

4" Fast Jack LED Power Surface Mount

Canopy

IMPORTANT INFORMATION

- This product is ETL listed for indoor dry locations.

- This product can be installed to a 4" electrical box with
round plaster ring, or to an octagon electrical box.

- Minimum electrical box volume must be 6 cubic inches
(98 cubic centimeters).

- For dimming information visit www.edgelighting.com.

- This product can be used with LED or halogen Fast Jack
fixtures.

SAVE THESE INSTRUCTIONS!

Install the Canopy

A

CROSSBAR

1: Loosen and remove the two #8-32 flat head screws from the
canopy to remove the crossbar.

1

#8-32 FLAT
HEAD SCREW

2: Turn the power to electrical box off.

3: Connect the white LED power supply wire to the neutral

power wire with a wire nut.

4: Connect the black LED power supply wire to the hot power
wire with a wire nut.

5: Place the LED power supply and wires inside the electrical
box.

1

CANOPY

B

5

3

LED POWER SUPPLY

4

1

C

ELECTRICAL BOX

6:

Make sure the crossbar is grounded in accordance with local

electrical codes.

7: Mount the crossbar to the electrical box with the two #8-32
screws provided.

6

7

CROSSBAR

8: Connect each canopy wire to one LED power supply low
voltage wire with a wire nut.

9: Place all wires inside the canopy.

E

ELECTRICAL BOX

#8-32 SCREW

7

D

8

10: Align and secure the canopy to the crossbar by tightening

the two provided #8-32 flat head screws.

ELECTRICAL BOX

8

9

CANOPY

10

CANOPY

#8-32 FLAT
HEAD SCREWS

CAUTION: Risk of Fire:

60 watt.

11:

Use fingers to tighten the Fast Jack fixture connector into

the Fast Jack canopy connector.

MAX load of Fast Jack LED canopy is

10

F

FAST JACK FIXTURE
CONNECTOR

11

CANOPY

FAST JACK CANOPY
CONNECTOR

2