Edge Lighting Sun 3 LED Components User Manual

904-SUN3-LL-03

© 2011 Edge Lighting. All Rights Reserved.

1718 W. Fullerton Ave

Chicago, IL 60614

Tel: [phone]

Fax: [phone]
www.edgelighting.com
[e-mail]

SUN3-LL_

PORT-LL_

Installation Instructions for STEP LIGHT KITS SUN3-LL & PORT-LL

IMPORTANT INFORMATION

- The SUN3-LL & PORT-LL are the accessory step light kits
that are used with Sun3 and Port fixtures respectively.

- The SUN3-LL and the PORT-LL come with a Micro Louver
Lens for controlling the glare, a 20 degree beam tilt film
for controlling the beam light, a neutral density film (gray)
to reduce the light level to 50%, a warm white film
(amber) to convert the light level to 2700K and a very
warm white film (yellow) to convert the light level to
2500K.

- The SUN-LLH & PORT-LLH do not come with any lenses or
films.

SAVE THESE INSTRUCTIONS!

Install the Lens

A

TRIM

LED BODY

2: Using fingers remove the retainer ring inside the trim. If
necessary use a flat screw driver or pair of pliers to start.

NOTE:

Do not remove the glass retainer ring which makes the

trim to be water proof.

1

1: Unscrew to remove the LED body from the trim.

B

TRIM

GLASS RETAINER RING

RETAINER RING

2

1

C

LENS HOLDER
GROOVE

NEUTRAL DENSITY

TEXTURED
SIDE

SPRING CLIP

3: Carefully remove the spring clip and one of the glass lenses.

NOTE:

installed in SUN-LL & PORT-LL, if removing them please make sure
to align the cut out portion of the louver and the film with the lens
holder tab. Use one of the three optional films.

The micro louver and the 20 degree film are already

GLASS
LENS

TAB

3

MICRO
LOUVER
LENS

SMOOTH
SIDE

LENS
HOLDER

GLASS
LENS

20 DEGREE
TILT LENS FILM

MICRO
LOUVER
LENS

MICRO LOUVER LENS BLADES

MUST BE ORIENTED IN THIS

MANNER TO WORK PROPERLY

NOTE:

green plastic) and the other side is textured (protected with a
clear plastic). The smooth side of the lens should face against the
trim glass lens. Remove protective plastics before applying the
film.

4

NOTE:

lenses. Make sure any lenses or films used with these accessories
are placed between the two glass lenses.

NOTE:

accessories. Use the second glass lens if eliminating the micro
louver and using the films only.

One side of the 20° film is smooth (protected with a

SUN3-LLH & PORT-LLH do not come with any films or

The second glass lens can be eliminated if using a few

4: Replace the spring clip making sure that it sits properly in
the lens holder groove.

D

TRIM

TRIM GROOVE

LENS HOLDER

5

5: Align the set screw on the lens holder with the groove on the

trim. Make sure that the spring clip side of the lens is in the
opposite direction of the trim.

6: Insert the lens holder inside the trim making sure that the
set screw on the lens holder fits inside the groove.

E

TRIM

OPTIONAL
GLASS LENS

LENS HOLDER

RETAINER RING

7

8: Replace and tighten the LED body completely into the trim.

6

SPRING CLIP

7: Place the optional glass lens (if using any) against the lens
holder. Replace and tighten the retainer ring to secure the
lens holder and glass lens in place.

F

TRIM

8

LED BODY

9: Refer to the installation instructions provided with the Sun3
or Port to complete the installation.

2