Edge Lighting Standoffs User Manual

© 2009 Edge Lighting. All Rights Reserved.

1718 W. Fullerton Ave

Chicago, IL 60614

Tel: [phone]

Fax: [phone]
www.edgelighting.com
[e-mail]

MS-1-_

904-MS-1-02

Installation Instructions for

Monorail 1" Rigid Standoff

IMPORTANT INFORMATION

- This product is ETL listed for indoor dry locations.

- The product is intended to be used with Edge Lighting
Monorail systems only.

- Use Monorail standoffs where the Monorail sections join
together and approximately every 3 feet throughout the
Monorail run.

SAVE THESE INSTRUCTIONS!

Install the Standoff

A

2

CEILING

3

1: Hold the Monorail section against the ceiling or use a plumb

bob to mark the standoff locations onto the ceiling (this may
require more than one person).

2: Tap the anchors onto the marked locations up to the
threaded portion with a hammer.

3: Screw the threaded portion of the anchors in with a Phillips
screwdriver.

ANCHOR

4: Mount the standoffs onto the anchors with the #8 screws
provided. Make sure that the cut out portion of the

standoffs lines up with the Monorail.

C

MONORAIL

5

1.5MM ALLEN
WRENCH

M3 SET
SCREW

5

B

4

5: Slide Monorail into the cut out portion of the standoffs. Hold

the Monorail against the standoffs (
than one person)
standoff with the 1.5mm Allen wrench.

#8 SCREW

1" STANDOFF

and tighten the M3 set screw on each

4

this may require more

1