Edge Lighting Direct-End Power Feed Canopies User Manual

904-MP-2SQ-FE-04

© 2009 Edge Lighting. All Rights Reserved.

1718 W. Fullerton Ave

Chicago, IL 60614

Tel: [phone]

Fax: [phone]
www.edgelighting.com
[e-mail]

MP-2SQ-FE-_

Installation Instructions for Monorail 2" Square Feed-End Power

Canopy

IMPORTANT INFORMATION

- This product is ETL listed for indoor dry locations.

- This product installs to Edge Lighting 2" electrical box only.

- Minimum electrical box volume must be 6 cubic inches
(98 cubic centimeter).

- This product should be installed by a qualified electrician.

SAVE THESE INSTRUCTIONS!

For New Construction

A

JOIST

A

SINGLE CEILING
FRAME STUD

ELECTRICAL BOX

For Double Ceiling Frame Stud,

2: use the Monorail 4"

standoff to mount the Feed-End Power Canopy closest to the
ceiling. Refer to the chart below to determine the 2"
electrical box distance from the ceiling frame stud.

DRY WALL

THICKNESS

1/2" 0.95"

5/8" 1.08"

CEILING DRYWALL

1.9"

STUD

A

1: For Single Ceiling Frame Stud, use the Monorail 2"

standoff to mount the Feed-End Power Canopy closest to the
ceiling. Refer to the chart below to determine the 2"
electrical box distance from the ceiling frame stud.

DRY WALL

THICKNESS

1/2" 0.29"

5/8" 0.42"

3/4"

B

JOIST

A

A

0.54"

CEILING DRYWALL

4"

3/4"

1.22"

DOUBLE CEILING
FRAME STUD

ELECTRICAL BOX

STUD

1

Install the Canopy

C

2

2

3: Place all wires inside the 2" electrical box.

4: Secure the power feed canopy to the 2" electrical box by

tightening the two provided #8-32 screws with the 3/32
Allen wrench.

NOTE: The low voltage wires should be present in the 2"

electrical box. Refer to the instructions provided with the remote
transformer to install the transformer and the low voltage wires
before proceeding with the steps below.

1: Turn the power to the 2" electrical box off.

2: Connect each low voltage wire coming from the remote

transformer to one power feed canopy wire with a wire nut.

D

3

#8-32SCREW

4

4

3/32 ALLEN
WRENCH

Install the Monorail to Power Feed Canopy

E

CANOPY END
CONNECTOR

1: Push the straight conductive connectors into the canopy end
connector.

F

1

STRAIGHT CONDUCTIVE
CONNECTOR

CANOPY END
CONNECTOR

STRAIGHT
CONDUCTIVE
CONNECTOR

2

MONORAIL

2

2: Push a Monorail section entirely onto the straight conductive
connectors. Make sure that Monorail section is
supported by Monorail standoffs.

2