Edge Lighting Dial LED User Manual

1718 W. Fullerton Ave

Chicago, IL 60614

Tel: [phone]

Fax: [phone]

www.edgelighting.com

© 2013 Edge Lighting. All Rights Reserved.

[e-mail]

Installation Instructions for DIAL LED

IMPORTANT INFORMATION

- RISK OF FIRE:
the ground for wet locations.

- This product is for wall mount applications only.

- This product can mount to a standard 4" electrical box
with a plaster ring or an octagon electrical box.

- This product is not dimmable.

SAVE THESE INSTRUCTIONS!

This product must be installed 4 ft above

Disassemble the Fixture & Install the Driver

DIAL-W-L1-SA

904-DIAL-W-L1-03

A

PHILLIPS
SCREW

1 1

2: Loosen the two M6 screws using the provided 3mm Allen

wrench to remove the backplate. Use a small flathead
screwdriver to remove the backplate from the glass shade.

C

LED DRIVER

FIXTURE

1

COVER

ELECTRICAL BOX

4

1: Loosen the two Phillips screws to remove the cover.

B

3MM ALLEN
WRENCH

GLASS
SHADE

3: Connect the blue (NEUTRAL) LED driver wire to the neutral
power wire with a wire nut.

4: Connect the brown (HOT) LED driver wire to the hot power
wire with a wire nut.

M6 SCREW

SMALL
SCREW
DRIVER

22

2

BACKPLATE

3

WIRE NUT

5: Place the LED driver and wire connections inside the
electrical box.

5

1

Install the Fixture

D

FIXTURE

2

BACKPLATE

SMALL
SCREW
DRIVER

FIXTURE
CONNECTOR

LED DRIVER
CONNECTOR

1

NOTE: Use the universal crossbar (provided) when

mounting the fixture to an octagon box. There will be a
1/16" gap between the fixture and the wall when the
universal crossbar is used. Caulking around the fixture will
be needed when the universal crossbar is used in outdoor
applications.

1: While holding the fixture, snap the fixture connector to the
LED driver connector making sure the connectors are locked
in place.

2: Make sure the backplate is grounded in accordance with local
electrical codes.

E

FIXTURE

BACKPLATE
CENTER HOLE

4

4

3: Align the two inner threaded screw holes on the backplate

toward bottom for the LEDs to light towards top of the wall
or toward the top for LEDs to light towards bottom of the
wall.

4: Mount the backplate to the electrical box holes with the two
#8-32 screws provided.

F

M6 SCREW

3MM ALLEN
WRENCH

9

FIXTURE

9

3

INNER THREADED
SCREW HOLE

5: Place the fixture completely onto the backplate. Replace and
tighten the two M6 screws with 3mm Allen wrench.

ELECTRICAL
BOX HOLE

G

PHILLIPS
SCREW

6

6

FIXTURE

6: Replace the cover and secure it to the fixture with the two
Phillips screws.

6

COVER

2