Edge Lighting Crystal Galaxy User Manual

1718 W. Fullerton Ave

Chicago, IL 60614

Tel: [phone]

Fax: [phone]

www.edgelighting.com

© 2012 Edge Lighting. All Rights Reserved.

[e-mail]

Installation Instructions for Crystal Galaxy

IMPORTANT INFORMATION

- Use this fixture indoors only.

- RISK OF FIRE: Use only the type of lamp and maximum
wattage indicated in this instruction manual.

- This product is ETL listed for indoor dry locations and
approved to be used at any height above the finished
floor.

SAVE THESE INSTRUCTIONS!

Adjust the Fixture Height

FJ-CRYGA16-12-SN

904-FJ-CRYGA16-01

A

COAXIAL CABLE

H

CRYSTAL

2: Loosen the M4 set screw on base of the coaxial fixture
connector with the 2mm Allen wrench provided. Do not

remove this set screw.

1

1: Cut the coaxial cable to the desired height (H) with a sharp

cutter. The overall fixture height is measured from the
bottom of the crystals to the end of the coaxial cable.

B

2MM ALLEN
WRENCH

M4 SET SCREW

2

3

1.5MM ALLEN
WRENCH

M3 SET
SCREW

3: Remove the M3 set screw on tip of the connector with the

1.5mm Allen wrench provided.

COAXIAL FIXTURE CONNECTOR

1

C

STRAIN RELIEF TUBE

4

4: Feed the coaxial cable through the conical nipple and flared

side of the strain relief tube. Slide the conical nipple and
strain relief tube down the coaxial cable.

CONICAL NIPPLE

5: Feed the coaxial cable into the coaxial fixture connector. The
coaxial cable will come to a stop point.

COAXIAL CABLE

E

1.5MM ALLEN WRENCH

M3 SET SCREW

WRINKLE

D

5

COAXIAL CABLE

6: Keep feeding the coaxial cable in until the inner wire is
visible in the screw hole of the fixture connector tip. The
outer metal jacket will start to wrinkle.

7: Hold the fixture connector in place. Replace and tighten the
M3 set screw on fixture connector tip with the 1.5mm Allen
wrench.

8

OUTER METAL JACK INNER WIRE

9: Push the strain relief tube completely into the coaxial
fixture connector. Make sure the slot on the strain relief
tube is not inline with the M4 set screw.

10: Tighten the M4 set screw with the 2mm Allen wrench.

8: Pull down the outer metal jacket to smooth the wrinkles.

7

6

F

2MM ALLEN WRENCH

M4 SET SCREW

9

STRAIN RELIEF TUBE

COAXIAL FIXTURE
CONNECTOR

10

22