Edge Lighting Cody LED Picture Light User Manual
© 2009 Edge Lighting. All Rights Reserved.
1718 W. Fullerton Ave
Chicago, IL 60614
Tel: 773-770-1195
Fax: 773-935-5613
www.edgelighting.com
info@edgelighting.com
CPL-12-_-P
Installation Instructions for Cody 12" Plug-In Picture Light
IMPORTANT INFORMATION
- This product is ETL listed for indoor location.
- This product is wall mounted only.
- This instruction shows a typical installation.
SAVE THESE INSTRUCTIONS!
Install the Fixture
904-CPL-12-P-01
A
HEAD
1
ARM
1: Rotate the Cody's head perpendicular to the arm making
sure the arm is completely inserted into the head swivel
connector. Tighten the M3 set screw on the swivel connector
with the provided 1.5mm Allen wrench to secure the head in
place.
B
1.5MM ALLEN
WRENCH
1
M3 SET SCREW
SWIVEL
CONNECTOR
HEAD
ARM
MOUNTING BRACKET
JOINING ARM
2
2: Insert the loose arm assembly (provided in the box) into the
other swivel connector and insert the joining arm into the
mounting bracket of the first arm. Tighten the M3 set screw
on the swivel connector and mounting bracket with the
1.5mm Allen wrench.
HEAD
1.5MM ALLEN
WRENCH
2
M3 SET SCREW
SWIVEL
CONNECTOR
ARM
1
C
MOUNTING BRACKET
NOTE: The Cody 12" plug-in comes with 9' of cord and
plug-in power supply. Make sure there is a power outlet
near to where Cody 12" will be mounted
3: Hold the mounting bracket against the wall where Cody 12"
will be mounted. Level the mounting bracket and mark the
bracket holes on the wall.
3
3
4
ANCHOR
WALL
5
6: Line up the mounting bracket holes with the anchors and
secure the fixture to the anchors with the four #8 screws
provided.
4: Tap the anchors onto the marked points into the wall up to
the threaded portion with a hammer.
5: Screw the threaded portion of the anchors in with the a
Phillips screwdriver.
D
ANCHOR
MOUNTING BRACKET
6
6
#8 SCREW
E
2MM ALLEN WRENCH
M4 SET SCREW
MOUNTING BRACKET
ARM
7
7
7: To adjust the height, loosen the four M4 set screw on the
mounting brackets with the provided 2mm Allen wrench.
Adjust the Cody to the desired height by sliding it up or
down. Tighten the four M4 set screws with the 2mm Allen
wrench.
2
Loading...