Edge Lighting Cody LED Picture Light User Manual

904-CPL-6-01

© 2009 Edge Lighting. All Rights Reserved.

1718 W. Fullerton Ave

Chicago, IL 60614

Tel: [phone]

Fax: [phone]
www.edgelighting.com
[e-mail]

CPL-6-_

Installation Instructions for Cody 6" Canopy Mount Picture Light

IMPORTANT INFORMATION

- This product is ETL listed for indoor location

- This product is wall mounted only.

- This product can mount to either a 4" square electrical box
with round plaster ring or an octagon electrical box.

- This instruction shows a typical installation.

SAVE THESE INSTRUCTIONS!

Install the Fixture

A

1

HEAD

1.5MM ALLEN
WRENCH

1

NOTE: The Cody 6" canopy mount must be installed right

above the electrical box.

2: Hold the mounting bracket against the wall above the
electrical box. Level the mounting bracket and mark the
bracket holes on the wall.

3: Tap the anchors onto the marked points into the wall up to
the threaded portion with a hammer.

4: Screw the threaded portion of the anchors in with the a
Phillips screwdriver.

M3 SET SCREW

SWIVEL
CONNECTOR

ARM

1: Rotate the Cody's head perpendicular to the arm making
sure the arm is completely inserted into the head. Tighten
the M3 set screw on the swivel connector with the provided

1.5mm Allen wrench to secure the head in place.

B

3

ANCHOR

WALL

4

ELECTRICAL
BOX

MOUNTING BRACKET

2

1

C

5: Connect the white LED power supply wire to the neutral

power wire with a wire nut.

6

7

5

6: Connect the black LED power supply wire to the hot power

wire with a wire nut.

7: Place the LED power supply and all wire connections inside
the electrical box.

WIRE NUT

LED POWER SUPPLY

ELECTRICAL BOX

8: Mount the crossbar assembly to the electrical box holes with
the provided #8-32 screws.

E

ANCHOR

MOUNTING
BRACKET

D

CROSSBAR
ASSEMBLY

#8-32 SCREW

POWER WIRE

9: Line up the mounting bracket holes with the anchors and
secure the fixture to the anchors with the two #8 screws
provided.

ELECTRICAL BOX

8

8

9

#8 SCREW

ELECTRICAL
BOX

10: To adjust the Cody height, loosen the two M4 set screw on
the mounting bracket with the provided 2mm Allen wrench.
Adjust the Cody by sliding it up or down. When the desired
height is achieved tighten the two M4 set screws with the
2mm Allen wrench.

F

M4 SET
SCREW

2MM ALLEN WRENCH

ARM

MOUNTING
BRACKET

10

2

G

11: Connect each low voltage LED power supply wire (red

wire) to one fixture wire with a wire nut.

12: Place the excess wires and wire nuts inside the electrical
box.

13: Line up the canopy cut out edge with the fixture wires.
Place the canopy onto the electrical box and tighten the
thumb nut to the crossbar assembly nipple.

CUTOUT

THUMB
NUT

13

14: Hang the frame cable into the mounting bracket slot.

I

COVER

11

11

12

FIXTURE HEAD

H

15: Rotate the fixture head to properly wash the picture with

light.

NOTE: The Cody 6" contains 6 watt integrated LED lamps. These

lamps are rated for 50,000 hours.

MOUNTING BRACKET SLOT

14

FRAME CABLE

PICTURE

15

3