Edge Lighting Cody 2 LED Picture Light User Manual

904-CPL2-6-01

© 2014 Edge Lighting. All Rights Reserved.

1718 W. Fullerton Ave

Chicago, IL 60614

Tel: [phone]

Fax: [phone]
www.edgelighting.com
[e-mail]

CPL2-6-_

Installation Instructions for Cody2 6" Canopy Mount Picture Light

IMPORTANT INFORMATION

- This product is ETL listed for indoor location

- This product is wall mounted only.

- This product can mount to either a 4" square electrical box
with round plaster ring or an octagon electrical box.

- This instruction shows a typical installation.

- Ensure that power to the junction box has been turned
OFF before beginning any electrical work.

SAVE THESE INSTRUCTIONS!

Install the Fixture

A

1: Rotate the Cody's head perpendicular to the arm making

1

HEAD

1.5MM ALLEN
WRENCH

1

M3 SET SCREW

SWIVEL
CONNECTOR

ARM

sure the arm is completely inserted into the head. Tighten
the M3 set screw on the swivel connector with the provided

1.5mm Allen wrench to secure the head in place.

B

MOUNTING BRACKET

NOTE: The Cody2 6" canopy mount must be installed right
above the electrical box.

2: Hold the mounting bracket against the wall above the
electrical box. Level the mounting bracket and mark the
bracket holes on the wall.

3: Tap the anchors onto the marked points into the wall up to
the threaded portion with a hammer.

4: Screw the threaded portion of the anchors in with the a
Phillips screwdriver.

3

ANCHOR

WALL

2

4

ELECTRICAL
BOX

1

C

5: Connect the white LED power supply wire to the neutral

power wire with a wire nut.

6

7

5

6: Connect the black LED power supply wire to the hot power

wire with a wire nut.
7: Place the LED power supply and all wire connections inside

the electrical box.

WIRE NUT

LED POWER SUPPLY

ELECTRICAL BOX

8: Mount the crossbar assembly to the electrical box holes with
the provided #8-32 screws.

E

ANCHOR

MOUNTING
BRACKET

D

CROSSBAR
ASSEMBLY

#8-32 SCREW

9: Line up the mounting bracket holes with the anchors and
secure the fixture to the anchors with the two #8 screws
provided.

ELECTRICAL BOX

8

8

9

#8 SCREW

ELECTRICAL
BOX

10: To adjust the Cody2 height, loosen the two M4 set screw
on the mounting bracket with the provided 2mm Allen
wrench. Adjust the Cody2 by sliding it up or down. When
the desired height is achieved tighten the two M4 set
screws with the 2mm Allen wrench.

F

M4 SET
SCREW

2MM ALLEN WRENCH

ARM

MOUNTING
BRACKET

10

2