Edge Lighting Cody 2 User Manual

© 2011 Edge Lighting. All Rights Reserved.

1718 W. Fullerton Ave

Chicago, IL 60614

Tel: [phone]

Fax: [phone]
www.edgelighting.com
[e-mail]

FJ-COD-2-_

M-COD-2-_

M2-COD-2-_

904-FJ-COD-2-01

Installation Instructions for

Cody 2 LED

IMPORTANT INFORMATION

- This product is ETL listed for indoor dry locations.

- The product is intended to be used with Edge Lighting
Monorail & Fast Jack Systems.

SAVE THESE INSTRUCTIONS!

Install the to the Monorail (MC-FJ-_)fixture

A

MONORAIL FAST
JACK HOUSING

HOUSING
CONNECTOR

(DISCARD)

2: Place the Monorail Fast Jack housing onto the Monorail and

use fingers to tighten the fixture housing connector to the
Fast Jack housing. Make sure that the fixture housing

connector is not cross threaded.

1

1: Remove the Monorail housing connector from the Monorail

Fast Jack housing and discard it.

MONORAIL FAST

B

JACK HOUSING

2

MONORAIL

FIXTURE HOUSING
CONNECTOR

2

Install the to Monorail 2 Circuit Connector (M2C-FJ-_)fixture

C

MONORAIL 2 CIRCUIT
FAST JACK HOUSING

HOUSING
CONNECTOR

(DISCARD)

2: Place the Monorail 2 Circuit Fast Jack housing onto the

Monorail 2 Circuit and use fingers to tighten the fixture
housing connector to the Fast Jack housing. Make sure

that the fixture housing connector is not cross
threaded.

1

1: Remove the Monorail 2 Circuit housing connector from the

Monorail 2 Circuit Fast Jack housing and discard it.

MONORAIL 2 CIRCUIT

D

FAST JACK HOUSING

MONORAIL 2 CIRCUIT

1

FIXTURE
CONNECTOR

HOUSING

1

1

CIRCUIT #1 CIRCUIT #2

E

0.05 ALLEN
WRENCH

3

#4-40 SET
SCREW

1
2
N

4

3: To power the fixture from circuit #1, top and bottom

(neutral) rails, tighten the #4-40 set screw on top of the
housing with the 0.05 Allen wrench. Make sure this set

screw connection is very tight.

4: To power the fixture from circuit #2, middle and bottom

(neutral) rails, remove the #4-40 set screw from top of the
housing and tighten it into the side threaded hole with the

0.05 Allen wrench. Make sure this set screw connection

1

is very tight.

2
N

To avoid shorting the system, do not use more than one

NOTE:

set screw to select a circuit on the Monorail 2 Circuit connector.

NOTE: Do not load either circuit over the maximum system

rating.

Install the Fixture to Fast Jack LED Canopy (FJP-2SQ-LED_,
FJP-4SQ-LED_, FJP-4RD-LED_)

1: Use fingers to tighten the Fast Jack fixture connector into

the Fast Jack canopy connector.

G

2

FIXTURE HEAD

F

FAST JACK CANOPY
CONNECTOR

2:

Rotate the fixture head to properly wash the wall with

light.

NOTE: The Cody 2 consumes 6 watts and contains integrated

LED lamps which are rated for 50,000 hours.

1

FAST JACK FIXTURE
CONNECTOR

2