Edge Lighting Canopy Cover Splice Box User Manual

1718 W. Fullerton Ave

Chicago, IL 60614

Tel: [phone]

Fax: [phone]

www.edgelighting.com

© 2011 Edge Lighting. All Rights Reserved.

[e-mail]

Installation Instructions for 3" Rectangle Canopy Cover

IMPORTANT INFORMATION

- This product is ETL listed for indoor dry locations.

- This product can only be installed to a 4.5" X 2.5"
rectangle electrical box (gangbox).

SAVE THESE INSTRUCTIONS!

Install the Canopy Cover

A

1

SOFT STRIP
WIRE

CANOPY

NOTE: The low voltage DC power supply wires should be present

in the electrical box before proceeding with the steps below. Refer
to the power supply instructions for more details.

1: Feed the soft strip power wires through the canopy center
hole.

2: Snap the cap onto the canopy center hole and the soft strip
wires.

3RE-WH

904-3RE-01

2

SOFT STRIP

CAP

3: Connect the black and red soft strip power wires to the black
and red transformer wires respectively with wire nuts.

WIRE

C

4

CANOPY

5

5

B

TRANSFORMER WIRES

3

CANOPY

4: Place all wire and wire nut connections inside the electrical
box.

5: Secure the canopy to the electrical box with the two #8-32
provided screws.

6: Refer to the instructions provided with the soft strip to
connect the power to soft strip.

ELECTRICAL
BOX

3

SOFT STRIP
WIRE

#8-32 SCREW

6

LOW VOLTAGE
WIRE

1