![](/html/c7/c7ad/c7add85d2068ddf5189391230de40616efb7a3090fc7b294b2bfa6f86a7f0550/bg1.png)
1718 W. Fullerton Ave
Chicago, IL 60614
Tel: 773-770-1195
Fax: 773-935-5613
www.edgelighting.com
© 2013 Edge Lighting. All Rights Reserved.
info@edgelighting.com
Installation Instructions for Bola Suspension
IMPORTANT INFORMATION
- This product is ceiling mounted only.
- This product mounts to either a 4" square electrical box
with round plaster ring or an octagon electrical box.
SAVE THESE INSTRUCTIONS!
Install the Fixture
BOLA-S-__-__-SM-BK
904-BOLA-S-01
A
1: Align the crossbar slots to the junction box holes, and then
mark the four holes on the crossbar to the ceiling.
CANOPY
MAXIMUM 91"
GLASS
GLOBE
CANOPY
MINIMUM 30"
GLASS
GLOBE
NOTE:
8" stem only or using additional combination of 20" and 12"
stems for a maximum overall height of 91".
Determine the desired overall fixture height using the
JUNCTION
B
BOX HOLE
1
CROSSBAR
SLOT
CROSSBAR
1
MARK
C
2: Tap the anchors onto the marked points up to the threaded
SURFACE
2
ANCHOR
BE FLUSH TO WALL
3
ANCHOR MUST
portion with a hammer.
3: Screw in the threaded portion of the anchors with a Phillips
screwdriver.
1
![](/html/c7/c7ad/c7add85d2068ddf5189391230de40616efb7a3090fc7b294b2bfa6f86a7f0550/bg2.png)
D
JUNCTION
BOX
CROSSBAR
4: Line up the crossbar to the anchors and secure it by
tightening the four #8 screws & washers.
5: Secure the crossbar to the junction box using the two #8-32
screws.
E
WASHER
#8 SCREW
#8-32 SCREW
6: Feed the fixture wires through the short stem & tighten
to the fixture hub completely.
7: (OPTIONAL) To extend the fixture height, feed the fixture
wires through the additional stem(s) & tighten the additional
stem(s) completely to the 8" stem.
5
4
F
CANOPY NIPPLE
8
CORD
STEM
ADDITIONAL
STEM(S)
7
SHORT STEM
8: Feed the fixture cord into the canopy and secure the canopy
to the stem by tightening the canopy nipple completely into
the stem.
STEM
CORD
6
FIXTURE
HUB
FIXTURE
NOTE: It is recommended a second person to hold the fixture
while the electrician connects the power to the fixture.
9:
Make sure that the canopy is grounded in accordance
with local electrical codes.
10: Connect the fixture white wire to the neutral power wire
with a wire nut.
11: Connect the fixture black wire to the hot power wire with
a wire nut.
G
11
JUNCTION BOX
CROSSBAR
10
CANOPY
2