Edge Lighting Alps User Manual

1718 W. Fullerton Ave

Chicago, IL 60614

Tel: [phone]

Fax: [phone]

www.edgelighting.com

© 2010 Edge Lighting. All Rights Reserved.

[e-mail]

Installation Instructions for Fast Jack Alps Pendant

IMPORTANT SAFETY INSTRUCTIONS

To reduce the risk of fire, electrical shock, exposure to
excessive UV radiation, or injury to persons:

- Use this fixture indoors only.

- Do not look directly at the lamp while the fixture is on.

- RISK OF FIRE: Use only the type of lamp and maximum
wattage indicated in this instruction manual.

- Never cover the halogen lamp with anything other than a
lamp shield provided by Edge Lighting and never place
flammable material close to the fixture.

- Never turn the fixture on and off by connecting and
disconnecting the halogen lamp.

- Do not touch the fixture head, shade or lamp shield while
the fixture is on. These surfaces may be VERY HOT.

- Do not touch lamp at anytime. Use a soft cloth instead as oil
from skin may damage lamp.

- It is normal for a new halogen lamp to produce minor
smoke when first turned on.

- Do not operate the luminaire with a missing or damaged
shield.

- Turn power off and allow to cool before replacing lamp.

IMPORTANT INFORMATION

- This product is ETL listed for indoor dry locations and
approved to be used at any height above the finished
floor.

SAVE THESE INSTRUCTIONS!

FJ-ALPS-_

904-FJ-ALPS-01

Adjust the Fixture Height

A

COAXIAL CABLE

1

H

GLASS SHADE

2: Loosen the M4 set screw on base of the coaxial fixture
connector with the 2mm Allen wrench provided. Do not

remove this set screw.

1: Cut the coaxial cable to the desired height (H) with a sharp

cutter. The overall fixture height is measured from the
bottom of the glass shade to the end of the coaxial cable.

B

2MM ALLEN
WRENCH

M4 SET SCREW

2

3

1.5MM ALLEN
WRENCH

M3 SET
SCREW

3: Remove the M3 set screw on tip of the connector with the

1.5mm Allen wrench provided.

COAXIAL FIXTURE CONNECTOR

1

C

STRAIN RELIEF TUBE

4

4: Feed the coaxial cable through the conical nipple and flared

side of the strain relief tube. Slide the conical nipple and
strain relief tube down the coaxial cable.

CONICAL NIPPLE

5: Feed the coaxial cable into the coaxial fixture connector. The
coaxial cable will come to a stop point.

COAXIAL CABLE

E

1.5MM ALLEN WRENCH

M3 SET SCREW

WRINKLE

D

5

COAXIAL CABLE

6: Keep feeding the coaxial cable in until the inner wire is
visible in the screw hole of the fixture connector tip. The
outer metal jacket will start to wrinkle.

7: Hold the fixture connector in place. Replace and tighten the
M3 set screw on fixture connector tip with the 1.5mm Allen
wrench.

8

OUTER METAL JACK INNER WIRE

9: Push the strain relief tube completely into the coaxial
fixture connector. Make sure the slot on the strain relief
tube is not inline with the M4 set screw.

10: Tighten the M4 set screw with the 2mm Allen wrench.

8: Pull down the outer metal jacket to smooth the wrinkles.

7

6

F

2MM ALLEN WRENCH

M4 SET SCREW

9

STRAIN RELIEF TUBE

COAXIAL FIXTURE
CONNECTOR

10

2