Edge Lighting Air LED User Manual

1718 W. Fullerton Ave

Chicago, IL 60614

Tel: [phone]

Fax: [phone]

www.edgelighting.com

© 2012 Edge Lighting. All Rights Reserved.

[e-mail]

Installation Instructions for Air LED Suspension

IMPORTANT INFORMATION

- This product is ETL listed for indoor locations.

- This product can ONLY be ceiling mounted.

- This product can mount to either a 4" square electrical box
with round plaster ring or an octagon electrical box.

SAVE THESE INSTRUCTIONS!

Install the Fixture

AIR-S-_-CH

904-AIR-S-02

A

2: Remove the two Phillip screws and lock washers on the

sides of the canopy, and carefully pull the crossbar out.

CANOPY

1

H

FIXTURE FRAME

1: Determine the desired fixture height (H), from the bottom of
the fixture frame to the top the canopy.

PHILLIPS
SCREW

2

CROSSBAR

LOCK
WASHER

CANOPY

2

2

B

C

ELECTRICAL BOX
MOUNTING HOLES

CROSSBAR

#8-32 SCREW

3: Mount the crossbar to the electrical box holes with the
provided #8-32 screws.

3

1

D

CROSSBAR

CANOPY

ELECTRICAL BOX

4

5

NOTE: It is recommended that one person holds the canopy

while the electrician installs it.

4: Connect the white LED driver wire to the neutral power wire
with a wire nut.

5: Connect the black LED driver wire to the hot power wire with
a wire nut.

E

6

6: Place all wires and wire nut connections inside the electrical

box.

7: Mount the canopy to the crossbar with the two Phillips
screws and lock washers.

F

CANOPY

8

TAB

AIRCRAFT
CABLE

CANOPY

8: To make any minor adjustments to the fixture height, p
the tabs on the canopy to slide the fixture frame up and
down until the desired height is achieved. Release the tab to
lock the aircraft cable in place.

9: Secure the crystal accessary to the fixture frame by
tightening the thumb nut to the threaded stud.

NOTE: The fixture contains integrated LED lamps rated for

50,000 hours. It consumes a total of 14 watts.

PHILLIPS
SCREW

7

LOCK
WASHER

ush

THREADED
STUD

CRYSTAL
ACCESSARY

9

THUMB
NUT

2