Edge Lighting 2 Power Feed Canopies User Manual

© 2009 Edge Lighting. All Rights Reserved.

1718 W. Fullerton Ave

Chicago, IL 60614

Tel: [phone]

Fax: [phone]
www.edgelighting.com
[e-mail]

MP-2SQ-1-_

904-MP-2SQ-1-03

Installation Instructions for

Monorail 2" Square Single Power Feed Canopy

IMPORTANT INFORMATION

- This product is ETL listed for indoor dry locations.

- This product installs to Edge Lighting 2" electrical box only.

- Minimum electrical box volume must be 6 cubic inches
(98 cubic centimeters).

- This product should be installed by a qualified electrician.

SAVE THESE INSTRUCTIONS!

Install the Canopy

A

NOTE: The low voltage wires should be present in the 2"

electrical box. Refer to the instructions provided with the remote
transformer to install the transformer and the low voltage wires
before proceeding with the steps below.

2

2

3: Place all wires inside the 2" electrical box.

4: Secure the power feed canopy to the 2" electrical box by

tightening the two provided #8-32 screws with the 3/32
Allen wrench.

1: Turn the power to electrical box off.

2: Connect each low voltage wire coming from the remote

transformer to one power feed canopy wire with a wire nut.

B

3

4

3/32 ALLEN WRENCH

#8-32 SCREW

4

1

Install the Monorail to Power Feed Canopy

c

CAP

1: Unscrew the cap from power housing.

2: Slightly loosen the 3/8-24 set screw on the cap with the

3/16 Allen wrench provided, DO NOT REMOVE IT.

POWER HOUSING

1

2

3/8-24 SET SCREW

D

3/16 ALLEN WRENCH

3: Place the Monorail into the power housing. Make sure that
the Monorail is supported by the standoffs. Refer to the
instructions provided with the standoffs.

4: Tighten the cap to the power housing. Make sure the cap
is not cross threaded.

E

CAP

5

3/8-24 SET SCREW

3

CAP

MONORAIL

5: Tighten the 3/8-24 set screw with the 3/16 Allen wrench
provided on the cap firmly for proper power connection.

POWER HOUSING

4

3/16 ALLEN WRENCH

2