Edge Lighting 20 Fast Jack Canopies User Manual

904-FJP-16RD-01

© 2012 Edge Lighting. All Rights Reserved.

1718 W. Fullerton Ave

Chicago, IL 60614

Tel: [phone]

Fax: [phone]
www.edgelighting.com
[e-mail]

FJP-16RD-_-20W-_

Installation Instructions for 5,7, & 9 Port Round Fast Jack Canopies

IMPORTANT INFORMATION

- This product is dimmable with a low voltage electronic
dimmer.

- This product can be installed to a 4" electrical box with
round plaster ring, or to an octagon electrical box.

SAVE THESE INSTRUCTIONS!

Install the Canopy

Install the Canopy

A

MOUNTING PLATE

#8-32 SCREW

1

CANOPY

Feed the power wires through mounting plate center hole.

2:

3:

Align the mounting plate slots with the electrical box holes
and secure it to the electrical box holes with the provided
two #8-32 screws.

C

1: Loosen and remove the six #8-32 screws around the canopy

to remove the mounting plate.

1

B

2

3

3

#8-32 SCREW

MOUNTING PLATE

4: Mark the three mounting plate holes on the ceiling.

4

MOUNTING PLATE

5: Tap the anchors through the mounting plate holes onto the
marked point up to the threaded portion with a hammer.

6: Screw in the threaded portion of the anchors with a Phillips
screwdriver.

D

ANCHOR

5

6

6

MOUNTING PLATE

1

E

7: Secure the mounting plate to the anchors with the provided

#8 screws and washers.

7

WASHER

#8 SCREW

8: Insert one end of the safety cable into the safety bracket of
mounting plate and the other end into the canopy safety
bracket.

7

7

MOUNTING PLATE

F

SAFETY BRACKET

8

SAFETY
CABLE

MOUNTING
PLATE

CANOPY

G

9: Make sure that the mounting plate is grounded in

accordance with local electrical codes.

10: Connect the white fixture wire to the neutral power wire
with a wire nut.

11: Connect the black fixture wire to the hot power wire with a
wire nut.

11 10

2