Edge Lighting 17 Port Linear Canopies Without Transformers User Manual

© 2012 Edge Lighting. All Rights Reserved.

1718 W. Fullerton Ave

Chicago, IL 60614

Tel: [phone]

Fax: [phone]
www.edgelighting.com
[e-mail]

FJC-33RE-_

Installation Instructions for 14 or 17 Port Rectangle Fast Jack

Canopy Only

IMPORTANT INFORMATION

- This product is ETL listed for indoor dry locations.

SAVE THESE INSTRUCTIONS!

Running the Power from a Remote Transformer to the
Fast Jack Canopy

904-FJC-33RE-01

A

ELECTRICAL BOX

MAX

1

1: Remove the fourteen #8-32 screws around the canopy to

remove the mounting plate.

20FT

FAST JACK
CANOPY

REMOTE
TRANSFORMER

CONDUIT

1: Run the low voltage wires from a remote transformer to
electrical box where Fast Jack canopy is going to be
installed. It is recommended to install the remote
transformer near the electrical box to avoid voltage drop.
Refer to the instructions provided with remote transformer
for low voltage wire size chart. Refer to the low voltage wire
size chart provided with the remote transformer.

Install the Canopy

B

#8-32 SCREW

1

CANOPY

MOUNTING PLATE

1

C

NOTE: It is recommended that a person to hold the mounting

plate while the electrician installs it.

2

3

#8-32 SCREW

3

MOUNTING PLATE

Feed the power wires through mounting plate center hole.

2:

3:

Align the mounting plate slots with the electrical box holes
and secure it to the electrical box holes with the provided
two #8-32 screws.

1

D

ANCHOR

4

5

4: Tap the anchors through the mounting plate holes onto the

marked point up to the threaded portion with a hammer.

5: Screw in the threaded portion of the anchors with a Phillips
screwdriver.

NOTE: All 4 anchors must be installed to balance the pendants

weight.

MOUNTING PLATE

6: Secure the mounting plate to the anchors with the provided
#8 screws and washers.

F

8

FAST JACK CANOPY

ELECTRICAL BOX

8

E

WASHER

6

6

#8 SCREW

7: Make sure that the mounting plate is grounded in
accordance with local electrical codes.

NOTE: Make sure a person holds the Fast Jack canopy while the

electrician connects the wires and completes the installation.

8: Connect each canopy wire to one low voltage transformer
wire with a wire nut.

G

#8-32 SCREW

9

MOUNTING PLATE

MOUNTING PLATE

9: Place all wires and wire nut connections inside the canopy.

10: Place the canopy onto the mounting plate and tighten the

fourteen #8-32 screws.

H

11

FAST JACK
FIXTURE
CONNECTOR

FAST JACK
CANOPY
PORT

10

FAST JACK CANOPY

CAUTION: Risk of Fire: The total load of the Fast Jack

canopy ports should not exceed the remote transformer rated
capacity.

11:

Use fingers to tighten each Fast Jack fixture connector into

one Fast Jack canopy port.

10

2