![](/html/10/10a1/10a1e1b0863dc2010c4a481a8451f6d2dc5a3176f82d3fc15cbb771a8e233e46/bg1.png)
© 2012 Edge Lighting. All Rights Reserved.
1718 W. Fullerton Ave
Chicago, IL 60614
Tel: 773-770-1195
Fax: 773-935-5613
www.edgelighting.com
info@edgelighting.com
FJC-12RD-_
Installation Instructions for 12" Round 3 & 4 Port Fast Jack
Canopy Only
IMPORTANT INFORMATION
- This product is ETL listed for indoor dry locations.
SAVE THESE INSTRUCTIONS!
Running the Power from a Remote Transformer to the
Fast Jack Canopy
904-FJC-12RD-01
A
ELECTRICAL BOX
1
1: Loosen and remove the three #8-32 screws from the canopy
to remove the mounting plate.
ELECTRICAL BOX
C
MAX
20FT
FAST JACK
CANOPY
REMOTE
TRANSFORMER
CONDUIT
#8-32
SCREW
2
1: Run the low voltage wires from a remote transformer to
electrical box where Fast Jack canopy is going to be
installed. It is recommended to install the remote
transformer near the electrical box to avoid voltage drop.
Refer to the instructions provided with remote transformer
for low voltage wire size chart. Refer to the low voltage wire
size chart provided with the remote transformer.
Install the Canopy
B
#8-32 SCREW
1
CANOPY
2: Feed the low voltage coming from the remote transformer
through mounting plate center hole.
3: Align the mounting plate slots with the electrical box holes
and secure it to the electrical box holes with the provided
two #8-32 screws.
MOUNTING PLATE
1
MOUNTING
PLATE
3
2
1
![](/html/10/10a1/10a1e1b0863dc2010c4a481a8451f6d2dc5a3176f82d3fc15cbb771a8e233e46/bg2.png)
D
5
6: Place all the wires and wire nut connections inside the
canopy.
5
4: Make sure that the mounting plate is grounded in
accordance with local electrical codes.
5: Connect each canopy wire to one low voltage transformer
wire with a wire nut.
E
ELECTRICAL BOX
6
7 7
7: Align and secure the canopy to the mounting plate by
tightening the three #8-32 screws.
F
8
FAST JACK
FIXTURE
CONNECTOR
8
FAST JACK
CANOPY
CONNECTOR
#8-32
SCREWS
CAUTION: Risk of Fire:
canopy ports should not exceed the remote transformer rated
capacity.
8:
Use fingers to tighten the Fast Jack fixture connector into
the Fast Jack canopy connector.
8
The total load of the Fast Jack
CANOPY
2