Edgecore Networks WAP5110 User Manual
Quick Start Guide
IEEE 802.11a/b/g/n Enterprise Access Point
WAP5110
N
OTE
:
For detailed access point (AP) installation information, refer to the
Installation Guide, which is on the Documentation CD included with the AP.
N
OTE
:
For Safety and Regulatory information, refer to the Safety and Regulatory
Information document included with the AP.
Installation Information
The AP includes its own built-in features for mounting the unit to a wall or
suspended ceiling T-rail.
Caution:
The planning and installation of the AP requires professional personnel
that are trained in the installation of radio transmitting equipment. The user is
responsible for compliance with local regulations concerning items such as
antenna power, use of lightning arrestors, grounding, and radio mast or tower
construction. Therefore, it is recommended to consult a professional contractor
knowledgeable in local radio regulations prior to equipment installation.
Follow these steps to install the AP:
1. Unpack the AP Unpack the AP and check the package contents.
◆ WAP5110 Enterprise Access Point
◆ AC Power adapter
◆ Console cable (RJ-45 to DB-9)
◆ Quick Start Guide (this guide)
◆ Regulatory and Safety Information
◆ Documentation CD — includes Installation Guide and Management Guide
www.smc.com
– 1 –
E042013-CS-R01
150200000556A
Quick Start Guide
1
2
1
2
1
2
1
2
2. Mount the AP After planning your installation, mount the unit on a wall or suspended ceiling
T-rail.
.
Mounting on a Wall
Set two screws in the wall 6.2 mm (2.4 in.) apart.
Slide the AP’s wall mounting slots down onto the screws so that the unit is secure.
.
Mounting on a Ceiling T-rail
Position the AP’s ceiling-mount clip holders on either side of the T-rail.
Turn the AP until the two clips lock the AP to the T-rail.
– 2 –
Loading...