Edgecore Networks WAP3110 User Manual

Safety and Regulatory Information

IEEE 802.11b/g/n Enterprise Access Point

WAP3110-L

This document provides information on switch safety, regulatory statements and
compliances. It includes these sections:

◆ “Compliances and Safety Statements” on page 1

◆ “Warnings and Cautionary Messages” on page 6

Compliances and Safety Statements

FCC Class B This device complies with Part 15 of the FCC Rules. Operation is subject to the

following two conditions: (1) This device may not cause harmful interference, and
(2) this device must accept any interference received, including interference that
may cause undesired operation.

This equipment has been tested and found to comply with the limits for a Class B
digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful interference in a residential
installation. This equipment generates, uses and can radiate radio frequency
energy and, if not installed and used in accordance with the instructions, may cause
harmful interference to radio communications. This transmitter must not be co­located or operating in conjunction with any other antenna or transmitter.
However, there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off and on, the user
is encouraged to try to correct the interference by one of the following measures:

◆ Reorient or relocate the receiving antenna

◆ Increase the separation between the equipment and receiver

◆ Connect the equipment into an outlet on a circuit different from that to which

the receiver is connected

◆ Consult the dealer or an experienced radio/TV technician for help

FCC Caution: Any changes or modifications not expressly approved by the party
responsible for compliance could void the user's authority to operate this
equipment.

www.smc.com

– 1 –

E042013-AP-R01

Safety and Regulatory Information

This transmitter must not be co-located or operating in conjunction with any other
antenna or transmitter.

Radiation Exposure Statement:

This equipment complies with FCC radiation exposure limits set forth for an
uncontrolled environment. This equipment should be installed and operated with
minimum distance 20 cm between the radiator and your body.

NCC (Taiwan) 低功率電波輻射性電機管理辦法：

第十二條 : 經型式認證合格之低功率射頻電機，非經許可，公司、商號或使用

者均不得擅自變更頻率、加大功率或變更原設計之特性及功能。

第十四條 : 低功率射頻電機之使用不得影響飛航安全及干擾合法通信；經發現

有干擾現象時，應立即停用，並改善至無干擾時方得繼續使用。前項合法通

信，指依電信法規定作業之無線電通信。低功率射頻電機須忍受合法通信或工

業、科學及醫療用電波輻射性電機設備之干擾。

CE Mark CE Mark Declaration of Conformance for EMI and Safety (EEC)

This is a class B product. In a domestic environment, this product may cause radio
interference, in which case the user may be required to take adequate measures.

National Restrictions

This device is intended for home and office use in all EU countries (and other
countries following the EU directive 1999/5/EC) without any limitation except for
the countries mentioned below:

Country Restriction Reason/Remark

Bulgaria None General authorization required for outdoor use and

France Outdoor use limited

to 10 mW e.i.r.p.
within the band
2454-2483.5 MHz

italy None If used outside of own premises, general authorization is

public service

Military Radiolocation use. Refarming of the 2.4 GHz band
has been ongoing in recent years to allow current relaxed
regulation. Full implementation planned 2012

required

Luxembourg None General authorization required for network and service

Norway Implemented This subsection does not apply for the geographical area

Russian
Federation

None Only for indoor applications

– 2 –

supply(not for spectrum)

within a radius of 20 km from the centre of Ny-Ålesund