Edgecore Networks ECWO3324 User Manual

Quick Start Guide

802.11ac Outdoor Stand-Alone/Cloud-Based Access Point

ECWO3300, 4300, 5300 Series

The ECWO3300/4300/5300 Series are a family of single- and dual-band (2.4/5 GHz)
access points (APs) that are housed in a waterproof enclosure for mounting
outdoors. The units include a built-in mounting bracket for attaching to a 1.5 to 6­inch pole and they can be powered through their Ethernet cable connection from a
power injector module that is installed indoors.

The ECWO3300/4300/5300 Series includes these models:

ECWO3320 — 2.4 GHz stand-alone AP with internal antennas
ECWO3320-L — 2.4 GHz controller-based AP with internal antennas
ECWO3324 — 2.4 GHz stand-alone AP with external antennas
ECWO3324-L — 2.4 GHz controller-based AP with external antennas
ECWO4320 — 5 GHz stand-alone AP with internal antennas
ECWO4320-L — 5 GHz controller-based AP with internal antennas
ECWO4324 — 5 GHz stand-alone AP with external antennas
ECWO4324-L — 5 GHz controller-based AP with external antennas
ECWO5320 — Dual-band stand-alone AP with 5 GHz internal antennas
ECWO5320-L — Dual-band controller-based AP with 5 GHz internal antennas
ECWO5324 — Dual-band stand-alone AP with external antennas
ECWO5324-L — Dual-band controller-based AP with external antennas

ECWO3320-C — 2.4 GHz cloud-based AP with internal antennas

ECWO3324-C — 2.4 GHz cloud-based AP with external antennas
ECWO4320-C — 5 GHz cloud-based AP with internal antennas

ECWO4324-C — 5 GHz cloud-based AP with external antennas
ECWO5320-C — Dual-band cloud-based AP with 5 GHz internal antennas
ECWO5324-C — Dual-band cloud-based AP with external antennas

www.edge-core.com

Note:

For Safety and Regulatory information, refer to the Safety and Regulatory

Information document included with the AP.

– 1 –

E052014-CS-R01
150200000891A

Safety and Regulatory Information

802.11ac Outdoor Stand-Alone/Cloud-Based Access Point

ECWO3300, 4300, 5300 Series

This document provides information on switch safety, regulatory statements and
compliances. It includes these sections:

◆ “Compliances and Safety Statements” on page 1

◆ “Warnings and Cautionary Messages” on page 7

Compliances and Safety Statements

FCC Class B This device complies with Part 15 of the FCC Rules. Operation is subject to the

following two conditions: (1) This device may not cause harmful interference, and
(2) this device must accept any interference received, including interference that
may cause undesired operation.

This equipment has been tested and found to comply with the limits for a Class B
digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful interference in a residential
installation. This equipment generates, uses and can radiate radio frequency
energy and, if not installed and used in accordance with the instructions, may cause
harmful interference to radio communications. This transmitter must not be co­located or operating in conjunction with any other antenna or transmitter.
However, there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off and on, the user
is encouraged to try to correct the interference by one of the following measures:

◆ Reorient or relocate the receiving antenna

◆ Increase the separation between the equipment and receiver

◆ Connect the equipment into an outlet on a circuit different from that to which

the receiver is connected

◆ Consult the dealer or an experienced radio/TV technician for help

FCC Caution: Any changes or modifications not expressly approved by the party
responsible for compliance could void the user's authority to operate this
equipment.

www.edge-core.com

– 1 –

E052014-CS-R01
150200000892A

Safety and Regulatory Information

This transmitter must not be co-located or operating in conjunction with any other
antenna or transmitter.

Operation within the 5.15 ~ 5.25GHz / 5.47 ~5.725GHz frequency range is restricted
to an indoor environment. The 5600-5650MHz band is disabled by software during
manufacturing and cannot be changed by the end user. This device meets all the
other requirements specified in Part 15E, Section 15.407 of the FCC Rules.

Radiation Exposure Statement:

This equipment complies with FCC radiation exposure limits set forth for an
uncontrolled environment. This equipment should be installed and operated with
minimum distance 20 cm between the radiator and your body.

Professional Installation Instructions

1. Installation personal

This product is designed for specific applications and needs to be installed by a
qualified person who has RF and related rules knowledge. The general user shall
not attempt to install or change the settings.

2. Installation location

The product shall be installed at a location where the radiating antenna can be kept
20 cm from nearby persons in normal operation conditions to meet regulatory RF
exposure requirements.

3. External antenna

Use only the antennas that have been approved by the applicant. Non-approved
antenna(s) may produce unwanted spurious or excessive RF transmitting power,
which may lead to the violation of FCC/IC limits and is prohibited.

4. Installation procedure

Please refer to user's manual for details.

5. Warning

Please carefully select the installation position and make sure that the final output
power does not exceed the limits set forcth in relevant rules. Violation of the rules
could lead to serious federal penalties.

Instructions d'installation professionnelle

1. Installation

Ce produit est destine a un usage specifique et doit etre installe par un personnel
qualifie maitrisant les radiofrequences et les regles s'y rapportant. L'installation et
les reglages ne doivent pas etre modifies par l'utilisateur final.

– 2 –

Safety and Regulatory Information

2. Emplacement d'installation

En usage normal, afin de respecter les exigences reglementaires concernant
l'exposition aux radiofrequences, ce produit doit etre installe de facon a respecter
une distance de 20 cm entre l'antenne emettrice et les personnes.

3. Antenn externe.

Utiliser uniiquement les antennes approuvees par le fabricant. L'utilisation d'autres
antennes peut conduire a un niveau de rayonnement essentiel ou non essentiel
depassant les niveaux limites definis par FCC/IC, ce qui est interdit.

4. Procedure d'installation

Consulter le manuel d'utilisation.

5. Avertissement

Choisir avec soin la position d'installation et s'assurer que la puissance de sortie ne
depasse pas les limites en vigueur. La violation de cette regle peut conduire a de
serieuses penalites federales.

CE Mark CE Mark Declaration of Conformance for EMI and Safety (EEC)

This is a class B product. In a domestic environment, this product may cause radio
interference, in which case the user may be required to take adequate measures.

National Restrictions

This device is intended for home and office use in all EU countries (and other
countries following the EU directive 1999/5/EC) without any limitation except for
the countries mentioned below:

Country Restriction Reason/Remark

Bulgaria None General authorization required for outdoor use and

France Outdoor use limited

to 10 mW e.i.r.p.
within the band
2454-2483.5 MHz

italy None If used outside of own premises, general authorization is

Luxembourg None General authorization required for network and service

public service

Military Radiolocation use. Refarming of the 2.4 GHz band
has been ongoing in recent years to allow current relaxed
regulation. Full implementation planned 2012

required

supply(not for spectrum)

Norway Implemented This subsection does not apply for the geographical area

Russian
Federation

Note:

Do not use the product outdoors in France.

None Only for indoor applications

– 3 –

within a radius of 20 km from the centre of Ny-Ålesund