Edgecore Networks ECW5410O User Manual

For a world always connected…

The ECW5410-O is an Wave 2 indoor 802.11a/b/g/n/ac dual-band, dual-radio enterprise indoor AP with a
4x4 MU-MIMO antenna configuration.
Through its Gigabit Ethernet port the 802.11ac dual-band wireless AP can connect to the backbone network.
The ECW5410-O supports 802.3at PoE, which enables the AP to be powered remotely by a PoE switch. An
AC power adapter option is also included for locations where PoE is not available.

Product Overview

ECW5410-O

802.11ac OCP Wireless Access Point

DATASHEET

Wireless 802.11ac Technology

Using 802.11ac MIMO (Multiple Input Multiple)
wireless technology, the AP supports three

and three receiving antennas that extend range and
increase the throughput by up to nine times that of

existing Wi-Fi.

Wave 2, MU-MIMO

Support 4 clients at the same time. Also, it supports
beamforming and channel bonding(80MHz160MHz)

Advanced Traffic Management

Support for up to sixteen Virtual Access Point (VAP)
interfaces per radio, which allows traffic to be separated
for different user groups within the same service area.

Each radio can support up to 100 wireless clients,

shared between all VAPs, whereby the clients associate
with each VAP in the same way as they would with
physically separate APs. This means that each VAP
can be configured with its own Service Set Identification
(SSID), security settings, VLAN assignments, and other
parameters, allowing the AP to serve a diverse range of
client needs from a single unit.

Dual-Band Access Point

Easy on your budget and simple to install, the AP uses
dynamic rate shifting to automatically match the best
connection speed, keeping users connected to the
network even while roaming.

Key Features and Benefits

Application Diagram

TEL: [phone] FAX: [phone]
1, Creation Rd. III, Hsinchu Science Park, Taiwan 30077
[e-mail]
www.edge-core.com

ECW5410-O Product Specifications

Physical Features Network Management

Standards

Wireless Frequency

Antenna

Warranty

Features

 One 10/100/1000BASE-T Gigabit Ethernet (RJ-45) port with

802.3at/af-compliant Power over Ethernet (PoE) support

 One 10/100/1000BASE-T Gigabit Ethernet (RJ-45)
 One console port(10/100/1000BASE-T) with an RJ-45 connector
 One USB Port (optional)
 One Reset Button
 Five LEDs: Power, WLAN 2.4G, WLAN 5G, Eth1/PoE, Eth2
 PoE 802.3at compliant

IEEE 802.11n 2.4 GHz and 5.0 GHz
IEEE 802.11ac/a 5.0 GHz
IEEE 802.11b/g, 2.4 GHz
IEEE 802.3, IEEE 802.3u, IEEE 802.3ab
IEEE 802.3af Power over Ethernet (PoE)
IEEE 802.11h Regulatory Domain Selection
IEEE 802.11i
Wi-Fi Multimedia (WMM)
Wireless Distribution System (WDS)

802.11g/n:

2.4 ~ 2.4835 GHz (US, Canada)

2.4 ~ 2.4835 GHz (ETSI, Japan)

802.11b:

2.4 ~ 2.4835 GHz (US, Canada)

2.4 ~ 2.4835 GHz (ETSI)

2.4 ~ 2.497 GHz (Japan)

802.11a/n/ac:

5.15 ~ 5.25 GHz (lower band) US/Canada, Europe, Japan

5.25 ~ 5.35 GHz (middle band) US/Canada, Europe, Japan

5.725 ~ 5.825 GHz (upper band) US/Canada

5.50 ~ 5.70 GHz Europe

5.47 ~ 5.725GHz

 Telent
 Web-based Management (HTTP and HTTPS)
 SNMP management v1/v2c
 Software download and upgrade by TFTP, HTTP
 Configuration file backup and restore
 System Information – AP status, station status, event logs
 SNTP
 Country selection
 IPv4 and IPv6 dual stack support
 Remote Management
 UPNP
 Upstream / Dwonstream Rate Limit

Type: PCB type
Gain: 4dBi in 2.4GHz, 5dBi in 5GHz

Please check www.edge-core.com for the warranty terms in
your country/region.

Wireless Features

 VAP (Virtual Access Point) support with up to 16

SSIDs(2.4GHz: 8, 5GHz: 8)

 Operation modes: AP Mode, Point-to-Point WDS, Point-to-

Multiple points WDS, WDS With AP

 Transmit power adjustment
 Dynamic Channel Selection for noisy environment
 Auto-channel selection
 Support Multi-cast

Security

 WEP 64/128-bits
 Wi-Fi Protected Access (WPA/WPA2)
 WPA/WPA2 (PSK) over WDS
 Secure SSH (Secure Sockets Shell), Telnet
 SSID broadcast enable/disable

Regulatory Compliance

FCC Part 15 Subpart B
CE

Radio Signal Certification

FCC Part 15C 15.247, 15.207 (2.4GHz)
EN 300 328
EN 301 489-1
EN 301 489-17

Mechanical

Dimensions: 190.88x194.76x38mm
Weight: 0.623kg

Power

Input: 100 or 240 VAC, 50-60 Hz
Output: 12V 2A (or Ethernet PoE 802.3af/ at compatible)
Power Consumption: 17.4 W maximum

Environmental Specification

Temperature:

Standard Operating: 0°C to 50°C
Storage: -20°C to 70°C

Humidity: 10% to 95% (non-condensing)

For More Information

To find out more about Edge-Core Networks products and solutions, visit
www.edge-core.com

About Edge-Core Networks

Edge-Core Networks is in the business of providing innovative network
solutions. In the service provider network, in the data center or in the cloud,
Edge-Core Networks delivers the software and systems that transform the
way the world connects. Edge-Core Networks serves customers and partners
worldwide. Additional information can be found at www.edge-core.com.

© Copyright 2012 Edge-Core Networks Corp. The information contained herein is subject to change
without notice. This document is for informational purposes only and does not set forth any warranty,
expressed or implied, concerning any equipment, equipment feature, or service offered by Edge-Core
Networks. Edge-Core Networks shall not be liable for technical or editorial errors or omissions contained
herein.