Edge-Core SAF51003I Quick Start Manual
– 1 –
Desktop Mount the Device
1. Attach the four rubber foot pads to the base of the device, and
then place it on a desktop or shelf.
Ground the Device
1. Ensure the device is properly grounded in compliance with ETSI
ETS 300 253. Verify that there is a good electrical connection to
the grounding point (no paint or isolating surface treatment).
2. Attach the grounding wire (#14 AWG) to the grounding point
on the device rear panel. Then connect the other end of the wire
to ground.
Connect Power
1. Connect the AC/DC power adapter to the DC jack on the
device.
2. Connect the AC/DC power adapter to an external AC power
source.
Verify Device is Powered On
1. Verify the device is powered on by checking the PWR LED.
When operating normally, the PWR LED should be on green.
Connect Network Cables
1. For the RJ-45 ports, connect 100-ohm Category 5, 5e or better
twisted-pair cable.
Note:
The device is an open platform with Ubuntu Linux
pre-installed, but no application software.
1
1
2
1
2
3
1
2
415
1
E082018-AP-R01
150200001998A
Network Security Platform
SAF51003I
1.
Network Security Platform SAF51003I
2. Four adhesive foot pads
3. AC/DC Power Adapter
4. Power Cord—either Japan, US, Continental Europe or UK
5. Console Cable—RJ-45 to DB-9
1
Package Contents
4
5
2
3
Quick Start Guide
– 2 –
2. As connections are made, check the port status LEDs to be sure
the links are valid.
■
Green — 1 Gbps mode
■
Amber — 10/100 Mbps mode
Connect to the Console Port
1. Connect a PC to the serial console port using the included
console cable.
2. Configure the PC’s serial port as follows:
■
115200 bps
■
8 characters
■
No parity
■
One stop bit
■
8 data bits
■
No flow control
3. Log in to the Ubuntu system using the default settings:
■
Username “root”
■
Passwo rd “accton”
SAF51003I Specifications
Note:
Device drivers can be downloaded from:
www.accton-nfv.com/support/open-download
6
Form Factor Compact desktop
Dimensions
(W x D x H):
300 x 200 x 38.5 mm (11.81 x 7.87 x 1.52 inches)
Weight 1.58 kg (3.48 lb)
CPUs SoC, Intel® Atom™ Processor for Communications
C3000 Series (FCBGA, 14nm), supports 2-4 cores
2.2 GHz (turbo 2.4 GHz)
Memory Sockets: 2x 260pin DDR4 SODIMM slot
Type: DDR4 1866/2133/2400 MHz ECC (64GB
Max)
Local Storage 1 x 2.5” 500GB HDD
1 x M.2 SATAIII SSD, support 2242/2280 type
I/O Interfaces 1 x USB 3.0 Type A
1 x RJ-45 serial console
1 x hardware reset button
Network
Interfaces
1 x RJ-45 GbE for DMZ
1 x RJ-45 port for WAN
8 x RJ-45 GbE for LAN
Expansion Type: 1 x Mini PCIe
Signal: PCIe x1 and USB 2.0
Accelerator Advanced Technologies: Intel® VT-x, Intel® VT-d,
SR-IOV, VMDq, QuickAssist, PECI over SMBUS,
eSPI, NC-SI, Core and Memory RAPL, Memory
OLTT and CLTT
Power Adapter Input: AC 110 to 240 @ 50/60 Hz
Output: 12 VDC, 5.0 A, 60 W
System
Cooling
2x PWM fans, supports smart-fan
Temperature Operating: 0 °C to 40 °C (32 °F to 104 °F)
Storage: -20 °C to 70 °C (-4 °F to 158 °F)
Humidity Operating: 20% to 90% (non-condensing)
Storage: 5% to 90% (non-condensing)
Compliances CE
FCC
RoHS 2.0
Quick Start Guide
Loading...