Edge ED305, ED306 User Guide

INTRODUCTION

This instruction manual is for your safety and must be adhered to at all times. Please read and
ensure that you fully understand the installation and set up procedures as explained. If you
are unclear on the installation or set up of your EDGE speakers please contact your nearest
authorised EDGE dealer.

Contents

2 x EDGE woofers

2 x EDGE tweeters

2 x EDGE crossovers

2 x woofer grills.

8 x Fixing screws.

1 x Cut out template.

2 x Lengths of speaker cable.

Warranty card

DO NOT EXPOSE THIS PRODUCT TO DAMP OR MOISTURE - doing so may result in re,

BEFORE WIRING DISCONNECT THE CABLE FROM THE POSITIVE BATTERY TERMINAL -

ENSURE GOOD AND CORRECT CONNECTIONS - failure to make the correct connections

DO NOT USE ANY FUNCTIONS OF THIS EQUIPMENT THAT MAY TAKE YOUR

CONCENTRATION AWAY FROM DRIVING YOUR VEHICLE - do not set up your amplier
whilst driving, doing so may result in an accident. For prolonged setting up, make sure that

KEEP THE VOLUME AT A LEVEL SO YOU CAN STILL HEAR OUTSIDE NOISE - failure to do

this may result in an accident. EDGE equipment is capable of producing sound levels that can

permanently damage your hearing. EDGE recommends caution when listening at high volume.

For safe and enjoyable listening the sound should be comfortable and clear without distortion.

Never connect any speaker lead to the car chassis. This can cause severe damage to your

Before drilling or cutting any holes, investigate the layout of your vehicle thoroughly.

Use caution when working near the fuel / hydraulic lines and electrical wiring.

Observe the correct polarity when wiring, improper phasing may cause a loss of bass

Ensure that no moving parts catch on the speaker or grill (e.g. window or door handles, or

failure to do so may result in electric shock or injury.

may result in re or damage to the product.

your vehicle is stationary and in a safe location.

WARNING

shock or damage to the product.

CAUTION

speaker /car radio /amplier.

response.

window glass inside the door)

Woofer Installation

Using the template provided nd a suitable mounting location

for the woofer.

Mark the mounting holes and pre drill the xing hole with a
2mm drill bit. If the grill is too be tted then place it over the

speaker and screw through both the grill and the speaker
using the provided screws. Be careful not to over tighten the
screws as it may cause the grill to break.

Tweeter Installation Guidelines

The tweeter can either be tted ush mount or surface

mount. Try and take into account the following when locating
a suitable position. For optimum staging try and locate a
position that is higher than the woofer but within twelve inches (maximum) of it.
It is vital that the tweeter is adjusted so that it is focused towards the listener.

Surface Mount Tweeter Installation

After nding a suitable position for the tweeters place the base of the tweeter casing in the

correct position.
Using this base mark the two mounting holes and the hole for the wire to pass through.

Cut out these holes using a 2mm drill for the xing screws and at least an 8mm hole for the
cable, ensure that the hole cut for the cable is big enough and will not cause the cable to

become chaffed in any way.
Pass the tweeter cable through the bottom of the case and through the previously drilled hole.
Secure the bass of the tweeter housing with the screws provided.

Finally, angle the tweeter so that it is focused towards the listener.