edesix Videotag VT-100 Series Quick Start Manual

VT-100 SERIES

QUICKSTART GUIDE

ED-006-012-04

CONTENTS

INTRODUCTION 3

HOW TO CHARGE YOUR VT-100 4

HOW TO USE YOUR VT-100 6

HOW TO POWER UP YOUR VT-100 6
IF YOUR VT-100 IS CONFIGURED TO LIVESTREAM 7
IF YOUR VT-100 IS NOT CONFIGURED TO LIVESTREAM 7
HOW TO STOP RECORDING 8

WEARING YOUR VT-100 9

ROTATABLE CLIP / ALLIGATOR CLIP 10
KLICK FAST STUD 11
SPORTS CAMERA PILLAR 12
EPAULETTE MOUNT 13
LANYARD 15

CARE FOR YOUR VIDEOTAG PRODUCT 16

REGULATORY INFORMATION 17

VT-100 Series - Quickstart Guide - ED-006-012-04

2

INTRODUCTION

Thank you for choosing the VideoTag VT-100. This simple guide will lead you through the set up and
use of your VT-100.

The VT-100 is designed to function on standby for up to three months. Therefore, it is necessary to

fully charge the device before rst use.

Lens

FRONT

Micro

USB Port

BACK

Microphone

LED

VT-100 Series - Quickstart Guide - ED-006-012-04

Standard or Custom

ID Card Holder

Power Button & LED

LED

Power Button & LED

Attachment
Point for Clip

3

HOW TO CHARGE YOUR VT-100

To charge, you will need either a USB charging cable (AC-USB-MICROB-100) or the VT-100 variant of
the 14 Slot Dock (VT-100-DOCK14).

USB Charging Cable

(AC-USB-MICROB-100)

VT-100 Series - Quickstart Guide - ED-006-012-04

VT-100 Variant - 14 Slot Dock

(VT-100-DOCK14)

4

While connected to power, the LED on the right side of the device will ash green while charging,

and will go a solid green when fully charged.

If the VT-100 is congured to connect to WiFi while docking, the back-right LED will ash blue when

searching for a WiFi connection, and will become a solid blue when a WiFi connection is found.

If your VT-100 has not already been congured by your system administrator, please see the Edesix
Admin Guide for details on how to congure your VT-100.

CHARGING

(Flashing Green)

SEARCHING FOR WIFI

(Flashing Blue)

CONNECTED TO WIFI

(Solid Blue)

VT-100 Series - Quickstart Guide - ED-006-012-04

5

HOW TO USE YOUR VT-100

HOW TO POWER UP YOUR VT-100

The VT-100 starts recording (and live streaming, if it has been congured to do so), as soon as it is

powered up.

To power up your device, press and hold either of the two buttons on the back of the device for two

seconds. The device will vibrate briey, and recording will start.

Press and hold either
of the power buttons

VT-100 Series - Quickstart Guide - ED-006-012-04

6