Edelbrock Victor Jr. 70067, Victor Jr. 70068 User Manual

©2008 Edelbrock Corporation Brochure #63-70067
Catalog #70067 & 70068
DC/mc
Page 1 of 2
Important: The wiring hardware and instructions included with this kit are intended for 12-volt electrical systems only. Before attempting to wire your Edelbrock Performer nitrous oxide system, examine and follow the wiring diagram on the following page. Please call the Edelbrock Technical department with any questions concerning electrical wiring.
1 1 Activation Micro Switch 2 2 Activation Micro Switch Mounting Nut 3 2 Activation Micro Switch Mounting Bolt 4 1 30 amp Relay 5 1 Wire Harness with Integral Relay/Fuse Holder 6 1 Red Lighted Toggle Switch 7 2 18/22g Female Spade Connector 8 2 14/16g Female Spade Connector
9 2 14/16g Male Spade Connector 10 2 16/18g Splice Connector 11 1 3/8” Ring Terminal 12 2 18/22g Ring Terminal #8 Stud 13 1 18/22g Ring Terminal #10 Stud 14 1 14/16g Male Spade Connector 15 1 Pushbutton
1
2
3
4
5
15
6
10
10
9
8
14
13
7
12
11
ELECTRICAL COMPONENTS BILL OF MATERIAL
1st Stage Nitrous Jet #1
1st Stage Nitrous Jet #2
1st Stage Fuel Jet #1
1st Stage Fuel Jet #2
2nd Stage Nitrous Jet #2
2nd Stage Nitrous Jet #1
2nd Stage Fuel Jet #1
2nd Stage Fuel Jet #2
Front of Engine
1st Stage Bar
2nd Stage Bar
N2O Jet Fuel Jet HP Gain Timing Adj.
38 39 100hp 32° Total 54 54 150hp 30° Total 61 58 200hp 28° Total 70 72 250hp 26° Total
N2O Jet Fuel Jet HP Gain Total GainTiming Adj.
38 39 100hp 200hp 28° Total 54 54 150hp 300hp 24° Total 61 58 200hp 400hp 20° Total 70 72 250hp 500hp 16° Total
1st Stage
2nd Stage
Dominator-Flange 2-Stage Jet Map
N2O Jet Fuel Jet HP Gain Timing Adj.
39 39 100hp 32° Total 48 46 150hp 30° Total 58 56 200hp 28° Total 69 69 250hp 26° Total
N2O Jet Fuel Jet Add. HP Total Gain Timing Adj.
39 39 100hp 200hp 28° Total 48 46 150hp 300hp 24° Total 58 56 200hp 400hp 20° Total 69 69 250hp 500hp 16° Total
1st Stage
2nd Stage
Square-Flange 2-Stage Jet Map
2-STAGE VICTOR
JR. UPGRADE KIT
(P/N 70067-70068)
Your upgrade kit comes supplied with longer 6AN lines to split from the feed line to the solenoids, and longer lines to extend from the solenoids to the plate.
Dyno testing was conducted using a mildly modified 500CI engine. Modifications included Edelbrock intake manifold, dyno headers and improved ignition. These tests were conducted using 950psi bottle pressure at 7.5psi fuel pressure.
Edelbrock recommends using Champion C-64-C or equivalent spark plugs as well as 100 Octane or higher racing fuel.
The Victor Jr. Series Nitrous Systems are intended for single plane manifolds only. Do not use a dual plane manifold with
the Victor Jr. Series Nitrous Systems.
©2008 Edelbrock Corporation Brochure #63-70067
Catalog #70067 & 70068
DC/mc
Page 2 of 2
GROUND
GROUND
GROUND
GROUND
BATTERY
1ST
STAGE
SOLENOID
1ST
STAGE
SOLENOID
2ND
STAGE
SOLENOID
2ND
STAGE
SOLENOID
MICRO
SWITCH
1ST STAGE RELAY
2ND STAGE RELAY
FUSE
HOLDER
RED RED
WHITE
WHITE
BLUE
BLUE
BLACK
BLACK
PUSHBUTTON
BLACK
SWITCHED +12V
Wire Color System Origin Destination Terminal Used
Red Main voltage supply Relay harness +12V Battery terminal Ring
Blue 1st stage solenoid power Relay harness Solenoid wires Male/Female spade White System arming signal Relay harness Arming switch “ON ACC” Female spade Black Arming switch power Arming switch “ground” Ground Female spade/ring
Red Arming switch power Arming switch “Supply Volts” Switched +12v Female spade Black System arming signal Relay harness Micro switch Female spade Black 1st stage trigger signal Micro switch Ground Female spade/ring
1st Stage Relay Origins and Destinations Map
Wire Color System Origin Destination Terminal Used
Red Main voltage supply Relay harness +12V Battery terminal Ring or Scotchlok
Blue 2nd stage solenoid power Relay harness Solenoid wires Male/Female spade White System arming signal Relay harness Arming switch “ON ACC” Female spade or Scotchlok Black System arming signal Relay harness Pushbutton Female spade Black 2nd stage trigger signal Pushbutton Micro Switch Scotchlok
2nd Stage Relay Origins and Destinations Map
2 STAGE WIRING DIAGRAM
Edelbrock Corporation, 2700 California St., Torrance, CA 90503
Tech Line: (800) 416-8628, Office: (310) 781-2222
E-Mail: Edelbrock@Edelbrock.com
Loading...