Edelbrock R09392S User Manual

2006 Edelbrock Corporation

Brochure No. 63-R09392S

Catalog #R09392S

Rev. 7/06 - BC/mc

Catalog #R09392S

Russell DOT Rear Brake Hose Kit

for 2006 Honda CBR1000RR

INSTALLATION INSTRUCTIONS

Please study these instructions carefully before installing your new Brake Hose Kit. If you have any questions, please call our Technical Hotline at: 1-800-416-8628, 7:00 am to 5:00 pm, Monday - Friday, Pacific Standard Time or e-mail us at Edelbrock@Edelbrock.com.

INSTALLATION PROCEDURE

IIMPORTANT NOTE: Do not allow the master cylinder to completely drain of brake fluid at any time during this process.

Also, use care when handling brake fluid, as it can quickly damage finished surfaces (paint, plating, etc.).

1. Remove factory rear brake hose, noting routing.

2. Install bent banjo hose end onto master cylinder so hose loops upward, similar to factory.

3. Install straight hose end onto caliper oriented approximately 30° inward

(See Fig. 1).

4. Use supplied cushion clamp to secure hose at factory location on swingarm.

5. Check hose clearance throughout entire suspension travel range.

6. Bleed system and check for leaks while applying pressure.

Edelbrock Corporation, 2700 California St., Torrance, CA 90503

Tech Line: 800-416-8628

Office: 310-781-2222

E-Mail: Edelbrock@Edelbrock.com

IMPORTANT NOTE:

Proper installation is the responsibility of the installer. Improper installation will void warranty and may

result in poor performance and engine or vehicle damage.

Fig 1