Edelbrock 651105 User Manual

©

2006 Edelbrock Corporation

Brochure No. 63-651105

Catalog #651105

Rev. 6/06 - BC/mc

MODIFICATION INSTRUCTIONS

Required for 2005-2006 Pontiac GTO (6.0L LS2)

Russell Fuel Hose Kit

Catalog #651105

Please study these instructions carefully before installing your new Fuel Hose Kit. If you have any questions, please call
our Technical Hotline at: 1-800-416-8628, 7:00 am to 5:00 pm, Monday - Friday, Pacific Standard Time or e-mail us
at [e-mail].

MODICATION PROCEDURE

3. Mark hose 1” from end and wrap masking or
strapping tape tightly around hose at cut point to
minimize fraying. Hold hose in vise to cut. Hose
can be cut with a pneumatic cutoff wheel or
hacksaw. Cut as straight and square as possible.
Remove tape after cutting hose

.

IMPORTANT NOTE:

Proper installation is the responsibility of the installer. Improper installation will void warranty and may

result in poor performance and engine or vehicle damage.

NOTE: Due to a difference in engine fuel inlet location, it is necessary to shorten the Russell Fuel Hose 1” for proper

fitment on 2005-2006 (6.0L LS2) models. Please follow the steps below to accomplish this:

1. Hold red socket feature of either hose end in a
vise (with soft jaws or a rag) and unscrew blue
nipple assembly from socket (counter-clockwise)
using a proper-sized chrome SAE wrench.

2. Remove socket from vise and then remove socket
from hose by pulling and twisting clockwise.

4. Hold socket in vise and push hose into socket
while turning counter-clockwise. Make sure
socket is seated against end of hose.

©

2006 Edelbrock Corporation

Brochure No. 63-651105

Catalog #651105

Rev. 6/06 - BC/mc

5. Apply assembly lube (motor oil, etc.) to threads on
nipple assembly and in socket. Insert nipple into
socket/hose and start threads by hand
(clockwise). Turn nipple with wrench until there is
less than 1/16” between nipple hex and socket.

Edelbrock Corporation, 2700 California St., Torrance, CA 90503

Tech Line: 800-416-8628

Office: 310-781-2222

E-Mail: [e-mail]

6. Flush hose with solvent or soapy water and blow
clean with compressed air or let air dry.

7. Install on vehicle and turn key on to pressurize fuel

system (Do not start engine). Check for leaks.